Dell PowerConnect W-7200 Series Reference Manual page 1482

Parameter
<profile-name>
channel <channel>
clone <source>
interface <interface>
measure-dur-mandatory
measure-duration <measure-
duration>
measure-mode
no
random-interval <random-
interval>
reg-class {1|12}
1482 | wlan bcn-rpt-req-profile
Description
Name of this instance of the profile. The name
must be 1-63 characters.
This option is used to set the Channel field in the
Beacon Report Request frame. The Channel
value can be set to one of the following:
The channel of the AP (when Measurement
l
Mode is set to either 'Passive' or 'Active-All
channels')
0 (when Measurement Mode is set to
l
'Beacon Table')
255 (when Measurement Mode is set to
l
'Active-Channel Report')
Creates a copy of the Beacon Report Request
Profile specified as the <source>.
<source> is the name of an existing Beacon
Report Request Profile from which parameter
values are copied.
This field is used to specify the radio interface for
transmitting the Beacon Report Request frame.
This value is used to set the "Duration Mandatory"
bit of the Measurement Request Mode field of the
Beacon Report Request frame.
This value is used to set the Measurement
Duration field in the Beacon Report Request
frame. The Measurement Duration is set to the
duration of the requested measurement. It is
expressed in units of TUs.
Indicates the mode used for the measurement.
The valid measurement modes are:
active-all-ch
active-ch-rpt
beacon-table
passive
Negates any configured parameter.
This value is used to set the Randomization
Interval field in the Beacon Report Request
frame. The Randomization Interval is used to
specify the desired maximum random delay in
the measurement start time. It is expressed in
units of TUs (Time Units). A Randomization
Interval of 0 in a measurement request indicates
that no random delay is to be used.
This option is used to specify the Regulatory
Class field in the Beacon Report Request frame.
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Range Default
— "default"
For 255
802.11b/g
band: 1
to 14
For
802.11a
band: 36
to 165
— —
0-1 1
— Disabled
0 – 65535 0
beacon-table
—
— —
0 – 65535 0
For —
802.11b/g
bands,
12. For
802.11a,
use 1