telnet
telnet {cli|soe}
Description
Enable telnet to the controller or to an AP through the controller.
Syntax
Parameter
cli
soe
Usage Guidelines
Use the cli option to enable telnet to the controller.
Use the soe option to enable telnet using the SoE protocol. This allows you to remotely manage an AP directly
connected to the controller.
Example
The following example enables telnet to the controller using the CLI.
(host) (config) #telnet cli
Command History
The command was introduced in ArubaOS 1.0
Command Information
Platforms
All platforms
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
Enable telnet using the CLI.
Enable telnet using Serial over Ethernet (SoE).
Licensing
Base operating system
Default
Disabled
Disabled
Command Mode
Config mode on master controllers
telnet | 1425