Dell PowerConnect W-7200 Series Reference Manual page 1486

wlan dot11k-profile
wlan dotllk <profile-name>
ap-chan-rpt-11a
ap-chan-rpt-11bg
bcn-measurement-mode {active|beacon-table|passive}
bcn-req-chan-11a
bcn-req-chan-11bg
bcn-req-time
clone <profile-name>
dot11k-enable
force-disassoc
handover-trigger-profile
lm-req-time
no ...
rrm-ie-profile
tsm-req-profile
tsm-req-time
Description
Configure a 802.11k radio profile.
Syntax
Parameter
<profile-name>
ap-chan-rpt-11a
ap-chan-rpt-11bg
bcn-measurement-mode
active
beacon-table
1486 | wlan dot11k-profile
Description
Name of this instance of the profile. The name must be 1-63 characters.
This value is sent in the 'Channel' field of the AP channel reports on the
'A' radio. You can specify values in the range 34 to 165.
This value is sent in the 'Channel' field of the AP channel reports on the
'BG' radio. You can specify values in the range 1 to 14.
Configures an active, beacon-table or passive beacon measurement
mode for the profile.
Enables active beacon measurement mode. In this mode, the client
sends a probe request to the broadcast destination address on all
supported channels, sets a measurement duration timer, and, at the end
of the measurement duration, compiles all received beacons or probe
response with the requested SSID and BSSID into a measurement
report.
NOTE: If the station doesn't support active measurement mode, it returns
a Beacon Measurement Report with the Incapable bit set in the
Measurement Report Mode field.
Enables beacon-table beacon measurement mode.In this mode, the
client measures beacons and returns a report with stored beacon
information for any supported channel with the requested SSID and
BSSID. The client does not perform any additional measurements. This
is the default beacon measurement mode.
NOTE: If a station doesn't support beacon-table able measurement
mode, it returns a Beacon Measurement Report with the Incapable bit
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Default
"default"
36
1
beacon-table
—
—