Displaying Traffic Statistics - Dell PowerConnect B-RX Configuration Manual

28
Displaying IPv4 IS-IS information
TABLE 137
This field...
IP address
Destination addresses

Displaying traffic statistics

The device maintains statistics for common IS-IS PDU types. To display the statistics, use either of
the following methods.
To display IS-IS PDU statistics, enter the following command at any level of the CLI.
BigIron RX# show isis traffic
Level-1 Hellos
Level-2 Hellos
Level-1 LSP
Level-2 LSP
Level-1 CSNP
Level-2 CSNP
Level-1 PSNP
Level-2 PSNP
Syntax: show isis traffic
This display shows the following information.
890
IS-IS detailed LSP database information (Continued)
Displays...
The IP address of the interface that sent the LSP. The device can use
this address as the next hop in routes to the addresses listed in the rows
below.
The rows of information below the IP address row are the destinations
advertised by the LSP. The device can reach these destinations by using
the IP address listed above as the next hop.
Each destination entry contains the following information:
•
•
•
•
•
•
•
Message Received
1029
1027
6
6
0
0
107
107
Metric – The value of the default metric, which is the IS-IS cost of
using the IP address above as the next hop to reach this
destination.
Device type – The device type at the destination. The type can be
one of the following:
End System – The device is an ES.
IP-Internal – The device is an ES within the current area.
The IP address and subnet mask are listed.
IS – The device is another IS. The NET (NSAP address) is
listed.
IP-Extended – Same as IP-Internal, except the device
uses the extended TLV fields described in
draft-ietf-isis-traffic-02.txt to carry the information.
IS-Extended – Same as IS, except the device uses the
extended TLV fields described in
draft-ietf-isis-traffic-02.txt to carry the information.
Message Sent
115
112
3
3
0
0
0
0
BigIron RX Series Configuration Guide
53-1001986-01