Configuring The Syslog Service; Displaying The Syslog Configuration - Dell PowerConnect B-RX Configuration Manual

Here is an example of how the Syslog messages are displayed.
telnet@BigIron RX# terminal monitor
Syslog trace was turned ON
SYSLOG: <9>BigIron RX, Power supply 2, power supply on left connector, failed
SYSLOG: <14>BigIron RX, Interface ethernet 1/6, state down
SYSLOG: <14>BigIron RX, Interface ethernet 1/2, state up

Configuring the Syslog service

The procedures in this section describe how to perform the following Syslog configuration tasks:
•
•
•
•
•
Logging is enabled by default, with the following settings:
•
•
•

Displaying the Syslog configuration

To display the Syslog parameters currently in effect on a device, enter the following command from
any level of the CLI.
BigIron RX> show logging
Syslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)
Static Log Buffer:
Dec 15 19:04:14:A:Fan 1, fan on right connector, failed
Dynamic Log Buffer (50 entries):
Dec 15 18:46:17:I:Interface ethernet 1/4, state up
Dec 15 18:45:21:I:Bridge topology change, vlan 4095, interface 4, changed
state to forwarding
Dec 15 18:45:15:I:Warm start
Syntax: show logging
The Syslog display shows the following configuration information, in the rows above the log entries
themselves.
BigIron RX Series Configuration Guide
53-1001986-01
Specify a Syslog server. You can configure the device to use up to six Syslog servers. (Use of a
Syslog server is optional. The system can hold up to 100 Syslog messages in an internal
buffer.)
Change the level of messages the system logs.
Change the number of messages the local Syslog buffer can hold.
Display the Syslog configuration.
Clear the local Syslog buffer.
Messages of all severity levels (Emergencies – Debugging) are logged.
By default, up to 3800 messages are retained in the local Syslog buffer. This cannot be
changed.
No Syslog server is specified.
Buffer logging: level ACDMEINW, 3 messages logged
level code: A=alert C=critical D=debugging M=emergency E=error
I=informational N=notification W=warning
Configuring the Syslog service
A
1263