Displaying 802.1X Statistics - Dell PowerConnect B-RX Configuration Manual

33
Displaying 802.1x information
BigIron RX# show dot1x config e 1/3
Port 1/3 Configuration:
AuthControlledPortControl
max-clients
multiple-clients
filter-strict-security
Syntax: show dot1x config ethernet <slot/port>
The following additional information is displayed in the show dot1x config command for an
interface.
TABLE 158
This field...
AuthControlledPortControl
multiple-hosts
max-clients
multiple-clients
filter-strict-security

Displaying 802.1x statistics

To display 802.1x statistics for an individual port, enter a command such as the following.
BigIron RX# show dot1x statistics e 3/3
Port 1/3 Statistics:
RX EAPOL Start:
RX EAPOL Logoff:
RX EAPOL Invalid:
RX EAPOL Total:
RX EAP Resp/Id:
RX EAP Resp other than Resp/Id: 1
RX EAP Length Error:
Last EAPOL Version:
Last EAPOL Source:
TX EAPOL Total:
TX EAP Req/Id:
TX EAP Req other than Req/Id:
Num Sessions:
Num Restricted Sessions:
Num Authorized Sessions:
Syntax: show dot1x statistics [all | ethernet <slot/port>]
The following table describes the information displayed by the show dot1x statistics command for
an interface.
968
: Auto
: 32
: Enable
: Enable
Output from the show dot1x config command for an interface
Displays...
The port control type configured for the interface. If set to auto,
authentication is activated on the 802.1x-enabled interface.
Whether the port is configured to allow multiple Supplicants accessing
the interface on the BigIron RX through a hub.
Refer to
for information on how to change this setting.
The maximum number of clients that can be authenticated on this
interface.
Shows if the interface is enabled or disabled for multiple client
authentication.
Shows if the interface is enabled or disabled for strict security mode.
"Allowing multiple 802.1x clients to authenticate"
0
0
0
2
1
0
1
0050.da0b.8bef
3
1
1
1
0
1
on page 964
BigIron RX Series Configuration Guide
53-1001986-01