Dell PowerConnect B-RX Configuration Manual page 1224

45
Displaying BGP4+ information
BigIron RX# show ipv6 bgp neighbor 2:2:2:2:: received-routes
There are 4 received routes from neighbor 2:2:2:2::
Searching for matching routes, use ^C to quit...
Status A:AGGREGATE B:BEST b:NOT-INSTALLED-BEST C:CONFED_EBGP D:DAMPED
E:EBGP H:HISTORY I:IBGP L:LOCAL M:MULTIPATH S:SUPPRESSED F:FILTERED
1
AS_PATH: 400
2
AS_PATH: 400
3
AS_PATH: 400
4
AS_PATH: 400
Syntax: show ipv6 bgp neighbor <ipv6-address> received-routes [detail]
The <ipv6-address> parameter displays route information received from a specified neighbor. You
must specify this address in hexadecimal using 16-bit values between colons as documented in
RFC 2373.
The detail keyword displays detailed route information. If you do not specify this parameter, a
summary of route information displays.
This display shows the following information:
TABLE 197
This field...
Number of BGP4+ Routes received
from a neighbor
Status codes
Prefix
Next Hop
Metric
LocPrf
1152
PrefixNext HopMetricLocPrfWeightStatus
2002::/642:2:2:2:: 01000BE
2003::/642:2:2:2:: 11000BE
2004::/642:2:2:2:: 11000BE
2005::/642:2:2:2:: 11000BE
Summary of route information received from a BGP4+ neighbor
Displays...
The number of routes displayed by the command.
A list of the characters the display uses to indicate the route's status.
The status code appears in the Status column of the display. The status
codes are described in the command's output.
The received route's prefix.
The IPv6 address of the next switch that is used when forwarding a
packet to the received route.
The value of the route's MED attribute. If the route does not have a
metric, this field is blank.
The degree of preference for the advertised route relative to other routes
in the local AS. When the BGP4+ algorithm compares routes on the
basis of local preferences, the route with the higher local preference is
chosen. The preference can have a value from 0 – 4294967295.
BigIron RX Series Configuration Guide
53-1001986-01