When Parameter Changes Take Effect - Dell PowerConnect B-RX Configuration Manual

TABLE 118
Command
redistribute
show
table-map
timers
update-time

When parameter changes take effect

Some parameter changes take effect immediately while others do not take full effect until the
router's sessions with its neighbors are reset.
Immediately
The following parameter changes take effect immediately:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
BigIron RX Series Configuration Guide
53-1001986-01
IPv4 BGP commands at different configuration levels (Continued)
Global
(iPv4 and
IPv6)
x
x
Enable or disable BGP.
Set or change the local AS.
Add neighbors.
Change the update timer for route changes.
Disable or enable fast external fallover.
Specify individual networks that can be advertised.
Change the default local preference, default information originate setting, or administrative
distance.
Enable or disable use of a default route to resolve a BGP4 next-hop route.
Enable or disable MED (metric) comparison.
Require the first AS in an Update from an EBGP neighbor to be the neighbor's AS.
Change MED comparison parameters.
Disable comparison of the AS-Path length.
Enable comparison of the router ID.
Enable next-hop recursion.
Change the default metric.
Disable or re-enable route reflection.
Configure confederation parameters.
Disable or re-enable load sharing.
Change the maximum number of load-sharing paths.
IPv4 address IPv4 address
family unicast family
multicast
x x
x x
x x
x x
Configuring BGP4
See
"Modifying redistribution parameters"
page 776
"Displaying BGP4 information"
"Using a table map to set the tag value"
page 779
"Changing the keep alive time and hold time"
on page 779
"Changing the BGP4 next-hop update timer"
on page 780
26
on
on page 814
on
739