Dell PowerConnect B-RX Configuration Manual page 1180

44
Displaying RIPng information
BigIron RX# show ipv6 rip route
IPv6 RIP Routing Table - 4 entries:
2000:4::/64, from ::, null
2002:c0a8:46a::/64, from ::, null
2999::1/128, from ::, null
5000:2::/64, from ::, null
Syntax: show ipv6 rip route [<ipv6-prefix>/<prefix-length> | <ipv6-address>]
The <ipv6-prefix>/<prefix-length> parameters restrict the display to the entries for the specified
IPv6 prefix. You must specify the <ipv6-prefix> parameter in hexadecimal using 16-bit values
between colons as documented in RFC 2373. You must specify the <prefix-length> parameter as a
decimal value. A slash mark (/) must follow the <ipv6-prefix> parameter and precede the
<prefix-length> parameter.
The <ipv6-address> parameter restricts the display to the entries for the specified IPv6 address.
You must specify this parameter in hexadecimal using 16-bit values between colons as
documented in RFC 2373.
This display shows the following information:
TABLE 182
This field...
RIPng Routing Table entries
<ipv6-prefix>/<prefix-length>
<ipv6-address>
Next-hop router
Interface
Source of route
Metric <number>
Tag <number>
Timers:
1108
(0)
CONNECTED, metric 1, tag 0, timers: none
CONNECTED, metric 1, tag 0, timers: none
(2)
CONNECTED, metric 1, tag 0, timers: none
(3)
CONNECTED, metric 1, tag 0, timers: none
RIPng routing table fields
Displays...
The total number of entries in the RIPng routing table.
The IPv6 prefix and prefix length.
The IPv6 address.
The next-hop router for this Brocade device. If:: appears, the route is
originated locally.
The interface name. If "null" appears, the interface is originated locally.
The source of the route information. The source can be one of the following:
•
RIP – routes learned by RIPng.
•
CONNECTED – IPv6 routes redistributed from directly connected
networks.
•
STATIC – IPv6 static routes are redistributed into RIPng.
•
BGP – BGP4+ routes are redistributed into RIPng.
•
ISIS – IPv6 IS-IS routes are redistributed into RIPng.
•
OSPF – OSPFv3 routes are redistributed into RIPng.
The cost of the route. The <number> parameter indicates the number of hops
to the destination.
The tag value of the route.
Indicates if the hold-down timer or the garbage-collection timer is set.
(1)
BigIron RX Series Configuration Guide
53-1001986-01