Dell PowerConnect B-RX Configuration Manual page 1294

Bigiron rx series supporting multi-service ironware v02.7.03
Hide thumbs Also See for PowerConnect B-RX:
Table of Contents

Advertisement

48
Displaying OSPFv3 information
BigIron RX# show ipv6 ospf routes
Current Route count: 4
*IA 2000:4::/64
*IA 2002:c0a8:46a::/64
*IA 2999::1/128
*IA 2999::2/128
Syntax: show ipv6 ospf routes [<ipv6-prefix>]
The <ipv6-prefix> parameter specifies a destination IPv6 prefix. (You do not need to specify the
length of the prefix.) If you use this parameter, only the route entries for this destination are shown.
For example, to display route information for the destination prefix 2000:4::, enter the following
command at any level of the CLI.
BigIron RX# show ipv6 ospf routes 2000:4::
Destination
*IA 2000:4::/64
These displays show the following information.
TABLE 216
This field...
Current Route Count (Displays
with the entire OSPFv3 route
table only)
Intra/Inter/External
(Type1/Type2) (Displays with
the entire OSPFv3 route table
only)
Equal-cost multi-path (Displays
with the entire OSPFv3 route
table only)
Destination
1222
Intra: 4 Inter: 0 External: 0 (Type1 0/Type2 0)
Equal-cost multi-path: 0
Destination
Next Hop Router
::
::
::
fe80::2e0:52ff:fe91:bb37
Next Hop Router
::
OSPFv3 route information
Displays...
The number of route entries currently in the OSPFv3 route table.
The breakdown of the current route entries into the following route types:
The number of equal-cost routes to the same destination in the OSPFv3 route
table. If load sharing is enabled, the router equally distributes traffic among the
routes.
The IPv6 prefixes of destination networks to which the Brocade device can
forward IPv6 packets. "*IA" indicates the next router is an intra-area router.
Options
Area
Outgoing Interface
V6E---R-- 0.0.0.0
ethe 3/2
V6E---R-- 0.0.0.0
ethe 3/2
--------- 0.0.0.0
loopback 2
V6E---R-- 0.0.0.0
ethe 3/2
Options
Area
Outgoing Interface
V6E---R-- 0.0.0.0
ethe 3/2
Inter – The number of routes that pass into another area.
Intra – The number of routes that are within the local area.
External1 – The number of type 1 external routes.
External2 – The number of type 2 external routes.
Cost Type2 Cost
1 0
1 0
0 0
1 0
Cost Type2 Cost
1 0
BigIron RX Series Configuration Guide
53-1001986-01

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bigiron rx series

Table of Contents