Dell PowerConnect B-RX Configuration Manual page 1273

BigIron RX(config)# ipv6 router ospf
BigIron RX(config-ospf6-router)# distribute-list prefix-list filterOspfRoutes in
Syntax: [no] distribute-list prefix-list <name> in [<interface>]
After this distribution list is configured, route 3010::/64 would be omitted from the OSPFv3 route
table
:
BigIron RX# show ipv6 ospf route
Current Route count: 4
*IA 3001::/64
*IA 3015::/64
*IA 3020::/64
*E2 6001:5000::/64
The following commands specify an IPv6 prefix list called filterOspfRoutesVe that denies route
3015::/64.
BigIron RX(config)# ipv6 prefix-list filterOspfRoutesVe seq 5 deny 3015::/64
BigIron RX(config)# ipv6 prefix-list filterOspfRoutesVe seq 10 permit ::/0 ge 1 le
128
The following commands configure a distribution list that applies the filterOspfRoutesVe prefix list
to routes pointing to virtual interface 10.
BigIron RX(config)# ipv6 router ospf
BigIron RX(config-ospf6-router)# distribute-list prefix-list filterOspfRoutes in
ve 10
After this distribution list is configured, route 3015::/64, pointing to virtual interface 10, would be
omitted from the OSPFv3 route table.
BigIron RX# show ipv6 ospf route
Current Route count: 4
*IA 3001::/64
*E2 3010::/64
*IA 3020::/64
*E2 6001:5000::/64
BigIron RX Series Configuration Guide
53-1001986-01
Intra: 3 Inter: 0 External: 1 (Type1 0/Type2 1)
Equal-cost multi-path: 0
Destination
Next Hop Router
::
fe80::2e0:52ff:fe00:10
::
fe80::2e0:52ff:fe00:10
Intra: 3 Inter: 0 External: 1 (Type1 0/Type2 1)
Equal-cost multi-path: 0
Destination
Next Hop Router
::
fe80::2e0:52ff:fe00:10
::
fe80::2e0:52ff:fe00:10
Configuring OSPFv3
Options Area
Outgoing Interface
--------- 0.0.0.1
ve 10
V6E---R-- 0.0.0.0
ve 10
--------- 0.0.0.0
ve 11
--------- 0.0.0.0
ve 10
Options Area
Outgoing Interface
--------- 0.0.0.1
ve 10
--------- 0.0.0.0
ve 10
--------- 0.0.0.0
ve 11
--------- 0.0.0.0
ve 10
48
Cost Type2 Cost
0 0
11 0
10 0
10 0
Cost Type2 Cost
0 0
10 0
10 0
10 0
1201