Displaying Ospf Neighbor Information - Dell PowerConnect B-RX Configuration Manual

25
Displaying OSPF information

Displaying OSPF neighbor information

To display OSPF neighbor information, enter the following command at any CLI level.
BigIron RX# show ip ospf neighbor
Port
v10
v11
v12
v13
v14
To display OSPF neighbor information by area, enter a command such as the following.
BigIron RX# show ip ospf neighbor area 1
Port
v10
Syntax: show ip ospf neighbor [router-id <ip-addr>] | [<num>] [area <ip-addr> | <num> ]
The router-id <ip-addr> parameter displays only the neighbor entries for the specified router.
The <num> parameter displays only the entry in the specified index position in the neighbor table.
For example, if you enter "1", only the first entry in the table is displayed.
These displays show the following information.
TABLE 112
Field
Port
Address
Pri
716
Address Pri
10.1.10.1 1
10.1.11.1 1
10.1.12.1 1
10.1.13.1 1
10.1.14.1 1
Address Pri
10.1.10.1 1
CLI display of OSPF neighbor information
Description
The port through which the device is connected to the neighbor.
The IP address of this device's interface with the neighbor.
The OSPF priority of the neighbor:
•
For multi-access networks, the priority is used during election of the Designated Router
(DR) and Backup designated Router (BDR).
•
For point-to-point links, this field shows one of the following values:
•
1 = point-to-point link
•
3 = point-to-point link with assigned subnet
State Neigh Address
FULL/DR 10.1.10.2
FULL/DR 10.1.11.2
FULL/DR 10.1.12.2
FULL/DR 10.1.13.2
FULL/DR 10.1.14.2
State Neigh Address
FULL/DR 10.1.10.2
Neigh ID Ev Op Cnt
10.65.12.1 5 2
10.65.12.1 5 2
10.65.12.1 5 2
10.65.12.1 5 2
10.65.12.1 5 2
Neigh ID Ev Op Cnt
10.65.12.1 5 2
BigIron RX Series Configuration Guide
53-1001986-01
0
0
0
0
0
0