Dell PowerConnect B-RX Configuration Manual page 957

TABLE 134
This field...
Passive State
MTU
Authentication Password
Level-1 Metric
Level-1 Priority
Level-1 Hello Interval
Level-1 Hello Multiplier
Level-1 Designated IS
Level-1 DIS Changes
Level-2 Metric
Level-2 Priority
Level-2 Hello Interval
Level-2 Hello Multiplier
Level-2 Designated IS
Level-2 DIS Changes
Next IS-IS LAN Level-1 Hello
Next IS-IS LAN Level-2 Hello
Number of active Level-1 adjacencies
Number of active Level-2 adjacencies
Circuit State Changes
Circuit State Adjacencies Changes
Rejected Adjacencies
Circuit Authentication Fails
BigIron RX Series Configuration Guide
53-1001986-01
IS-IS Interface information (Continued)
Displays...
The passive state determines whether the interface is allowed to form
an IS-IS adjacency with the IS at the other end of the circuit. The state
can be one of the following:
•
•
The maximum length supported for IS-IS PDUs sent on this interface.
The password assigned to the IS-IS interface.
The default-metric value that the device inserts in IS-IS Level-1 PDUs for
this interface.
The priority of this IS to be elected as the Designated IS for Level-1 in
this broadcast network.
The number of seconds the software waits between sending Level-1
hello PDUs to the IS at the other end of the circuit.
The number by which the software multiplies the hello interval to
calculate the hold time set in Level-1 Hello PDUs sent on the circuit.
The NET of the Level-1 Designated IS.
The number of times the NET of the Level-1 Designated IS has changed.
The default-metric value that the device inserts in IS-IS Level-2 PDUs for
this interface.
The priority of this IS to be elected as the Designated IS for Level-2 in
this broadcast network.
The number of seconds the software waits between sending Level-2
Hello messages to the IS at the other end of the circuit.
The number by which the software multiplies the hello interval to
calculate the hold time set for Level-2 Hello PDUs sent on this circuit.
The NET of the Level-2 Designated IS.
The number of times the NET of the Level-2 Designated IS has changed.
Number of seconds before next Level-1 Hello PDU will be transmitted by
the device.
Number of seconds before next Level-2 Hello PDU will be transmitted by
the device.
The number of ISs with which this interface has an active Level-1
adjacency.
The number of ISs with which this interface has an active Level-2
adjacency.
The number of times the state of the circuit has changed.
The number of times an adjacency has started or ended on this circuit.
The number of adjacency attempts by other ISs rejected by the device.
The number of times the device rejected a circuit because the
authentication did not match the authentication configured on the
device.
Displaying IPv4 IS-IS information
FALSE – The passive option is disabled. The interface can form an
adjacency with the IS at the other end of the link.
TRUE – The passive option is enabled. The interface cannot form
an adjacency, but can still advertise itself into the area.
28
885