Dell PowerConnect B-RX Configuration Manual page 1200

45
Displaying BGP4+ information
The <table-entry-number> parameter specifies the table entry with which you want the display to
start. For example, if you specify 100, the display shows entry 100 and all entries subsequent to
entry 100.
The age <seconds> parameter displays only the routes that have been received or updated more
recently than the number of seconds you specify.
The as-path-access-list <name> parameter filters the display using the specified AS-path ACL.
The as-path-filter <number> parameter filters the display using the specified AS-path filter.
The best keyword displays the routes received from neighbors that the switch selected as the best
routes to their destinations.
The cidr-only keyword lists only the routes whose network masks do not match their class network
length.
The community <number> parameter lets you display routes for a specific community. You can
specify local-as, no-export, no-advertise, internet, or a private community number. You can specify
the community number as either two five-digit integer values of up to 1– 65535, separated by a
colon (for example, 12345:6789) or a single long integer value.
The community-access-list <name> parameter filters the display using the specified community
ACL.
The community-filter <number> parameter lets you display routes that match a specific community
filter.
The detail keyword lets you display more details about the routes. You can refine your request by
also specifying one of the other parameters after the detail keyword.
The local keyword displays routes that are local to the switch.
The neighbor <ipv6-address> parameter displays routes learned from a specified BGP4+ neighbor.
The nexthop <ipv6-address> option displays the routes for a specified next-hop IPv6 address. You
must specify this address in hexadecimal using 16-bit values between colons as documented in
RFC 2373.
The no-best keyword displays the routes for which none of the routes to a given prefix were selected
as the best route. The IPv6 route table does not contain a BGP4+ route for any of the routes listed
using this option.
The prefix-list <name> parameter filters the display using the specified IPv6 prefix list.
The regular-expression <regular-expression> parameter filters the display based on a regular
expression. For more information about regular expressions, refer to the "Configuring BGP4"
chapter in the Router Configuration Guide.
The route-map <name> parameter filters the display using the specified route map. The software
displays only the routes that match the match statements in the route map. The software
disregards the route map's set statements.
The summary keyword displays summary information for the routes.
The unreachable keyword displays the routes that are unreachable because the switch does not
have a valid RIPng, OSPFv3, IPv6 IS-IS, or static IPv6 route to the next hop.
1128 BigIron RX Series Configuration Guide
53-1001986-01