Dell PowerConnect B-RX Configuration Manual page 960

28
Displaying IPv4 IS-IS information
The <lsp-id> parameter displays summary information about a particular LSP. Specify an LSPID for
which you want to display information in HHHH.HHHH.HHHH.HH-HH format, for example,
3333.3333.3333.00-00. You can also enter name.HH-HH, for example, RX.00-00.
The detail parameter displays detailed information about the LSPs. Refer to
information"
The l1 and level1 parameters display the Level-1 LSPs only. You can use either parameter.
The l2 and level2 parameters display the Level-2 LSPs only. You can use either parameter.
The show isis database summary display shows the following information.
TABLE 136
This field...
LSPID
LSP Seq Num
LSP Checksum
LSP Holdtime
ATT
P
OL
Displaying detailed information
To display detailed information for all the LSPs in the device's LSP databases, enter the following
command at any level of the CLI.
888
on page 888.
IS-IS summary LSP database information
Displays...
The LSP ID, which consists of the source ID (6 bytes), the pseudonode (1
byte), and LSPID (1 byte).
NOTE: If the address has an asterisk ( * ) at the end, this indicates that
The sequence number of the LSP.
The checksum calculated by the device that sent the LSP and used by
the device to verify that the LSP was not corrupted during transmission
over the network.
The maximum number of seconds during which the LSP will remain
valid.
NOTE: The IS that originates the LSP sets the timer for the LSP. As a
A 4-bit value extracted from bits 4 – 7 in the Attach field of the LSP.
The value in the Partition option field of the LSP. The field can have one
of the following values:
•
•
The value in the LSP database overload field of the LSP. The field can
have one of the following values:
•
•
the LSP is locally originated.
result, LSPs do not all have the same amount of time remaining
when they enter the device's LSP database.
0 – The IS that sent the LSP does not support partition repair.
1 – The IS that sent the LSP supports partition repair.
0 – The overload bit is off.
1 – The overload bit is on, indicating that the IS that sent the LSP is
overloaded and should not be used as a IS-IS transit router for that
level.
"Displaying detailed
BigIron RX Series Configuration Guide
53-1001986-01