Dell PowerConnect B-RX Configuration Manual page 1359

TABLE 224
Message level
Notification
Notification
Notification
Notification
Notification
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
BigIron RX Series Configuration Guide
53-1001986-01
Brocade Syslog messages (Continued)
Message
DOT1X issues software but not physical port
up indication of Port <portnum> to other
software applications
DOT1X issues software but not physical port
down indication of Port <portnum> to other
software applications
Authentication Enabled on <portnum>
Authentication Disabled on <portnum>
MAC Authentication succeeded for
<mac-address> on <portnum>
Cold start
Warm start
<user-name> login to USER EXEC mode
<user-name> logout from USER EXEC mode
<user-name> login to PRIVILEGED mode
<user-name> logout from PRIVILEGED mode
SNMP Auth. failure, intruder IP: <ip-addr>
Interface <portnum>, state up
Interface <portnum>, state down
Interface <portnum>, line protocol up
Interface <portnum>, line protocol down
Syslog messages
Explanation
The device has indicated that the specified
port has been authenticated, but the actual
port may not be active.
The device has indicated that the specified is
no longer authorized, but the actual port may
still be active.
The multi-device port authentication feature
was enabled on the on the specified
<portnum>.
The multi-device port authentication feature
was disabled on the on the specified
<portnum>.
RADIUS authentication was successful for the
specified <mac-address> on the specified
<portnum>.
The device has been powered on.
The system software (flash code) has been
reloaded.
A user has logged into the USER EXEC mode
of the CLI.
The <user-name> is the user name.
A user has logged out of the USER EXEC
mode of the CLI.
The <user-name> is the user name.
A user has logged into the Privileged EXEC
mode of the CLI.
The <user-name> is the user name.
A user has logged out of Privileged EXEC
mode of the CLI.
The <user-name> is the user name.
A user has tried to open a management
session with the device using an invalid
SNMP community string.
The <ip-addr> is the IP address of the host
that sent the invalid community string.
A port has come up.
The <portnum> is the port number.
A port has gone down.
The <portnum> is the port number.
The line protocol on a port has come up.
The <portnum> is the port number.
The line protocol on a port has gone down.
The <portnum> is the port number.
A
1287