Specifying A Port Version; Specifying A Static Group; Setting The Interface Mld Version; Displaying Mld Information - Dell PowerConnect B-RX Configuration Manual

Syntax: ipv6 mld version <version-number>
Enter 1or 2 for <version-number> Default version 2

Specifying a port version

At the interface level, you can specify the MLD version for a physical port within a virtual interface.
You can set the version by entering a command such as the following at the interface level.
BigIron RX(config-vif-401)#ipv6 mld port-ver 1 eth 3/1
Syntax: mld port-ver <version-number>
Specify 1 or 2 for <version-number>.

Specifying a static group

A multicast group is usually learned when an MLDv1 report is received. You can configure static
group membership without having to receive an MLDv1 report by entering a command such as the
following at the interface level.
BigIron RX(config-vif-401))#ipv6 mld static-group ffe0::4c8 eth 3/1
To configure a Static Group on a physical interface, enter a command such as the
following:
BigIron RX (config-if-e1000-5/23)#ipv6 mld static ff01::6f
Syntax: ipv6 mld static-group <multicast-group-address> [ethernet <port-number> [ethernet
Enter the IPv6 multicast group address for the <multicast-group-address>.
Enter number of the port that will be included in this static group for the ethernet <port-number>
parameter. The asterisk (*) in the syntax above means that you can enter as many port numbers as
you want to include in the static group. For a virtual routing interface (ve), specify the physical
Ethernet ports on which to add the group address.

Setting the interface MLD version

You can use this command to set the MLD version (1 or 2) for the interface. You can select the
version of MLD by entering a command such as the following at the interface level.
BigIron RX(config-lbif-1)#ipv6 mld version
Syntax: ipv6 mld version <version-number>
Enter 1or 2 for <version-number>. Default is version 2

Displaying MLD information

The sections below present the show commands for MLD.

Displaying MLD group information

To display the list of multicast groups, enter a command such as the following.
BigIron RX Series Configuration Guide
53-1001986-01
Multicast Listener Discovery and source specific multicast protocols (MLDv2)
<port-number> | to <port-number>]* ]
49
1251