Dell PowerConnect B-RX Configuration Manual page 1376

E
BGP4
Commands
always-compare-med
as-path-filter <num> permit | deny <as-path>
as-path-ignore
clear ip bgp damping [<ip-addr> <ip-mask>]
clear ip bgp flap-statistics [regular-expression
<regular-expression> | <address> <mask> | neighbor
<ip-addr>]
clear ip bgp neighbor <ip-addr> [soft in prefix-filter]
clear ip bgp neighbor <ip-addr> | <peer-group-name> soft
in
clear ip bgp neighbor all | <ip-addr> | <peer-group-name>
| <as-num> [soft-outbound | soft [in | out]]
clear ip bgp neighbor all | <ip-addr> | <peer-group-name>
| <as-num> traffic
clear ip bgp neighbor all | <ip-addr> | <peer-group-name>
| <as-num>
last-packet-with-error | notification-errors
clear ip bgp routes [<ip-addr>/<prefix-length>]
clear ip bgp traffic
client-to-client-reflection
cluster-id <num> | <ip-addr>
community-filter <num> permit | deny <num>:<num> |
internet | local-as | no-advertise | no-export
compare-routerid
always-compare-med
confederation identifier <num>
confederation peers <num>
[<num> ...]
dampening [<half-life> <reuse> <suppress>
<max-suppress-time>]
default-information-originate
default-local-preference <num>
default-metric <num>
1304
See ...
"Configuring the device to always compare MEDs"
page 749
"Defining an AS-path filter" on page 743
"Disabling or re-enabling comparison of the AS-path
length" on page 750
"Removing route dampening from a route"
page 804
"Removing route flap dampening"
"Clearing route flap dampening statistics"
page 806
"Clearing route flap dampening statistics"
page 813
"Sending and receiving ORFs"
"Placing a policy change into effect"
"Dynamically refreshing routes"
"Clearing traffic counters" on page 812
"Clearing diagnostic buffers" on page 814
"Clearing and resetting BGP4 routes in the IP route
table" on page 812
"Clearing traffic counters" on page 812
"Disabling or re-enabling client-to-client route
reflection" on page 751
"Configuring a route reflector"
"Configuration procedures" on page 784
"Defining a community filter" on page 744
"Enabling or disabling comparison of the router IDs"
on page 751
"Configuring the device to always compare MEDs"
page 749
"Configuring a BGP confederation"
"Configuring a BGP confederation"
"Configuring route flap dampening"
"Originating the default route"
"Changing the default local preference"
"Changing the default metric used for redistribution"
on page 756
BigIron RX Series Configuration Guide
on
on
on page 813
on
on
on page 800
on page 807
on page 809
on page 751
on
on page 753
on page 753
on page 755
on page 755
on page 756
53-1001986-01