Clearing Bgp4+ Local Route Information; Clearing Bgp4+ Neighbor Information - Dell PowerConnect B-RX Configuration Manual

NOTE
Clearing the dampening statistics for a route does not change the dampening status of the route.
To clear all the route dampening statistics, enter the following command at the Privileged EXEC
level or any of the Config levels of the CLI:
BigIron RX# clear ipv6 bgp flap-statistics
Syntax: clear ipv6 bgp flap-statistics [<ipv6-prefix>/<prefix-length> | neighbor <ipv6-address> |
The <ipv6-prefix>/<prefix-length> parameter clears route flap dampening statistics for a specified
IPv6 prefix. You must specify the <ipv6-prefix> parameter in hexadecimal using 16-bit values
between colons as documented in RFC 2373. You must specify the <prefix-length> parameter as a
decimal value. A slash mark (/) must follow the <ipv6-prefix> parameter and precede the
<prefix-length> parameter.
The neighbor <ipv6-address> parameter clears route flap dampening statistics only for routes
learned from the neighbor with the specified IPv6 address.
The regular-expression <regular-expression> parameter is a regular expression.

Clearing BGP4+ local route information

You can clear locally imported or routes redistributed into BGP4+.
To clear all local route information, enter the following command at the Privileged EXEC level or any
of the Config levels of the CLI.
BigIron RX# clear ipv6 bgp local routes
Syntax: clear ipv6 bgp local routes

Clearing BGP4+ neighbor information

You can perform the following tasks related to BGP4+ neighbor information:
•
•
•
•
•
Clearing BGP4+ neighbor diagnostic buffers
You can clear the following BGP4+ neighbor diagnostic information in buffers:
•
•
To display these buffers, use the last-packet-with-error keyword with the show ipv6 bgp neighbors
command. For more information about this command, refer to
BGP4+ neighbor"
BigIron RX Series Configuration Guide
53-1001986-01
regular-expression <regular-expression>]
Clear diagnostic buffers.
Reset a session to send and receive Outbound Route Filters (ORFs).
Close a session, or reset a session and resend/receive an update.
Clear traffic counters.
Clear route flap dampening statistics.
The first 400 bytes of the last packet that contained an error.
The last NOTIFICATION message either sent or received by the neighbor.
on page 1151.
Clearing BGP4+ information
"Displaying last error packet from a
45
1119