Displaying Ipv4 Is-Is Information; Displaying The Is-Is Configuration In The Running-Config; Displaying The Name Mappings - Dell PowerConnect B-RX Configuration Manual

Bigiron rx series supporting multi-service ironware v02.7.03
Hide thumbs Also See for PowerConnect B-RX:
Table of Contents

Advertisement

28

Displaying IPv4 IS-IS information

The level-1 | level-2 parameter applies the change to only the level you specify. If you do not use
this parameter, the change applies to both levels.
Displaying IPv4 IS-IS information
You can display the following information:

Displaying the IS-IS configuration in the running-config

You can display the global IS-IS configuration commands that are in effect on the device using the
following CLI method.
NOTE
The running-config does not list the default values. Only commands that change a setting or add
configuration information are displayed.
To list the global IS-IS configuration commands in the device's running-config, enter the following
command at any level of the CLI.
BigIron RX# show isis config
router isis
net
end
The running-config shown in this example contains the command that enables IS-IS and a
command that configures a NET.
To display the interface configuration information in the running-config, enter one of the following
commands at any level of the CLI.
Syntax: show isis config

Displaying the name mappings

To display the mappings, enter the following command at any level of the CLI.
880
The active configuration (the IS-IS commands in the running-config) – refer to
IS-IS configuration in the running-config"
Name mappings –
"Displaying the name mappings"
Neighbor information –
"Displaying neighbor information"
Neighbor adjacency changes –
Interface information –
"Displaying interface information"
Route information –
"Displaying route information"
LSP database entries –
"Displaying LSP database entries"
Traffic statistics –
"Displaying traffic statistics"
Error statistics –
"Displaying error statistics"
20.00e0.5200.0001.00
show running-config
write terminal
on page 880
on page 880
"Displaying IS-IS Syslog messages"
on page 886
on page 890
on page 891
"Displaying the
on page 881
on page 882
on page 883
on page 887
BigIron RX Series Configuration Guide
53-1001986-01

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bigiron rx series

Table of Contents