Specifying An Ipv6 Snmp Trap Receiver; Restricting Web Management Access To An Ipv6 Host By Specifying An Ipv6 Acl; Restricting Web Management Access To An Ipv6 Host; Configuring An Ipv6 Syslog Server - Dell PowerConnect B-RX Configuration Manual

Specifying an IPv6 SNMP trap receiver

You can specify an IPv6 host as a trap receiver to ensure that all SNMP traps sent by the device will
go to the same SNMP trap receiver or set of receivers, typically one or more host devices on the
network. To do so, enter a command such as the following.
BigIron RX(config)# snmp-server host ipv6 2001:efff:89::13
Syntax: snmp-server host ipv6 <ipv6-address>
The <ipv6-address> you specify must be in hexadecimal format using 16-bit values between colons
as documented in RFC 2373.
Restricting web management access to an IPv6 host by
specifying an IPv6 ACL
You can specify an IPv6 ACL that restricts Web management access to management functions on
the device. For example.
BigIron RX(config)# access-list 12 deny host 2000:2383:e0bb::2/128 log
BigIron RX(config)# access-list 12 deny 30ff:3782::ff89/128 log
BigIron RX(config)# access-list 12 deny 3000:4828::fe19/128 log
BigIron RX(config)# access-list 12 permit any
BigIron RX(config)# web access-group ipv6 12
Syntax: web access-group ipv6 <ipv6 ACL name>
where <ipv6 ACL name> is a valid IPv6 ACL.

Restricting web management access to an IPv6 host

You can restrict Web management access to the device to the IPv6 host whose IP address you
specify. No other device except the one with the specified IPv6 address can access the Brocade
device's Web management interface. For example.
BigIron RX(config)# web client ipv6 3000:2383:e0bb::2/128
Syntax: web client ipv6 <ipv6-address>
The <ipv6-address> you specify must be in hexadecimal format using 16-bit values between colons
as documented in RFC 2373.

Configuring an IPv6 Syslog server

To specify an IPv6 Syslog server, enter a command such as the following.
BigIron RX(config)# log host ipv6 2000:2383:e0bb::4/128
Syntax: log host ipv6 <ipv6-address> [<udp-port-num>]
The <ipv6-address> you specify must be in hexadecimal using 16-bit values between colons as
documented in RFC 2373.
The <udp-port-num> optional parameter specifies the UDP application port used for the Syslog
facility.
BigIron RX Series Configuration Guide
53-1001986-01
43
IPv6 host support
1067