Displaying Pim Traffic Statistics; Pim-Ssmv4 - Dell PowerConnect B-RX Configuration Manual

Displaying PIM traffic statistics

To display PIM traffic statistics, enter the following command at any CLI level.
BigIron RX(config-pim-router)# show ip pim traffic
Port
e3/8
v1
v2
Total 37
IGMP Statistics:
Total Recv/Xmit 85/110
Total Discard/chksum
Syntax: show ip pim traffic
NOTE
If you have configured interfaces for standard PIM (dense mode) on the BigIron RX, statistics for
these interfaces are listed first by the display.
This display shows the following information.
This field...
Port
Hello
J/P
Register
RegStop
Assert
Total Recv/Xmit
Total Discard/chksum

PIM-SSMv4

Source Specific mode is similar to Sparse mode, but instead of simply joining a group, the receiver
uses IGMPv3 messages to join a group sent from a specific source. This way, instead of the receiver
getting multiple copies of the same stream from multiple sources, it will only receive traffic from
the one source to which it joins.
BigIron RX Series Configuration Guide
53-1001986-01
Hello J/P
[Rx Tx] [Rx
19 19 32
18 19 0
0 19 0
57 32
0/0
Register
Tx] [Rx Tx]
0 0 0
20 0 0
0 0 16
0 0 0
Displays...
The port or virtual interface on which the PIM interface is configured.
The number of PIM Hello messages sent or received on the interface.
The number of Join/Prune messages sent or received on the interface.
NOTE: Unlike PIM dense, PIM Sparse uses the same messages for Joins
and Prunes.
The number of Register messages sent or received on the interface.
The number of Register Stop messages sent or received on the
interface.
The number of Assert messages sent or received on the interface.
The total number of IGMP messages sent and received by the BigIron
RX.
The total number of IGMP messages discarded, including a separate
counter for those that failed the checksum comparison.
PIM-SSMv4
RegStop Assert
[Rx Tx] [Rx
37 0 0
0 0 0
0 0 0
0 0 0
23
Tx]
0
0
0
0
617