Dell PowerConnect B-RX Configuration Manual page 731

BigIron RX(config)# vlan 100
BigIron RX(config-vlan-100)# multicast static-group 224.10.1.1 include 10.43.1.12
uplink
To configure the snooping device to statically join all multicast streams on the uplink interface
excluding the stream with source address 10.43.1.12, enter commands such as the following.
BigIron RX(config)# vlan 100
BigIron RX(config-vlan-100)# multicast static-group 224.10.1.1 exclude 10.43.1.12
uplink
Configuring multicast static group <port-list> per VLAN
When the multicast static-group <group-address> <port-list> command is enabled on a snooping
VLAN, the snooping device will add the ports to the outgoing interface list of the multicast group
entry in the forwarding table as if IGMP joins were received from these ports. These ports will not
be aged out from the multicast group for not responding to the IGMP queries.
The multicast static-group <group-address> <port-list> command can be configured under the
VLAN configuration level only.
To configure the physical interface ethernet 2/4 to statically join a multicast group, enter
commands such as the following.
BigIron RX(config)# vlan 100
BigIron RX(config-vlan-100)# multicast static-group 224.10.1.1 ethernet 2/4
To configure the physical interface ethernet 3/4 to statically join a multicast stream with source
address of 10.43.1.12 in the include mode, enter commands such as the following.
BigIron RX(config)# vlan 100
BigIron RX(config-vlan-100)# multicast static-group 224.10.1.1 include 10.43.1.12
ethernet 3/4
To configure the physical interface ethernet 3/4 to statically join all multicast streams on the uplink
interface excluding the stream with source address of 10.43.1.12, enter commands such as the
following.
BigIron RX(config)# vlan 100
BigIron RX(config-vlan-100)# multicast static-group 224.10.1.1 exclude 10.43.1.12
ethernet 3/4
Syntax: [no] multicast static-group <group-address> uplink
Syntax: [no] multicast static-group <group-address> <port-list>
IGMP v3 commands
Syntax: [no] multicast static-group <group-address> [include l exclude <source-address>] uplink
Syntax: [no] multicast static-group <group-address> [include l exclude <source-address>]
The group-address parameter specifies the group multicast address.
The include or exclude keyword indicates a filtering action. You can specify which source (for a
group) to include or exclude. The include or exclude keyword is only supported on IGMPv3.
The source-address parameter specifies the IP address of the multicast source. Each address must
be added or deleted one line per source.
BigIron RX Series Configuration Guide
53-1001986-01
<port-list>
Configuring IP multicast traffic reduction
23
659