Dell PowerConnect B-RX Configuration Manual page 1315

BigIron RX# show ipv6 pim rp-candidate
Next Candidate-RP-advertisement in 00:00:10
RP: 1be::11:21
Candidate-RP-advertisement period: 60
This example show information displayed on a device that is a candidate RP. The following example
shows the message displayed on a device that is not a candidate RP.
BigIron RX# show ipv6 pim rp-candidate
This system is not a Candidate-RP.
Syntax: show ipv6 pim rp-candidate
This display shows the following information.
This field...
Candidate-RP-advertisement in
RP
group prefixes
Candidate-RP-advertisement period
Displaying RP-to-group mappings
To display RP-to-group-mappings, enter the following command at any CLI level.
BigIron RX# show ipv6 pim rp-map
Idx Group address
--------------------------------------------------------------------------------
1
2
3
BigIron RX#
Syntax: show ipv6 pim rp-map
This display shows the following information.
This field...
Index
Group address
RP address
BigIron RX Series Configuration Guide
53-1001986-01
group prefixes:
ff00:: / 8
ff7e:a40:2001:3e8:27:0:1:2 2001:3e8:27::a
ff7e:140:2001:3e8:16:0:1:2 2001:3e8:16::1
Displays...
Indicates how many seconds will pass before the BSR sends its next RP
message.
NOTE: This field appears only if this device is a candidate RP.
Indicates the IPv6 address of the Rendezvous Point (RP).
NOTE: This field appears only if this device is a candidate RP.
Indicates the multicast groups for which the RP listed by the previous field
is a candidate RP.
NOTE: This field appears only if this device is a candidate RP.
Indicates how frequently the BSR sends candidate RP advertisement
messages.
NOTE: This field appears only if this device is a candidate RP.
RP address
ff1e::1:2 2001:3e8:255:255::17
Displays...
The index number of the table entry in the display.
Indicates the IPv6 PIM Sparse multicast group address using the listed RP.
Indicates the Iv6 address of the Rendezvous Point (RP) for the listed PIM
Sparse group.
49
IPv6 PIM sparse
1243