Displaying MRP diagnostics
To display MRP diagnostics results, enter the following command on the Master node.
BigIron RX(config)# show metro 2 diag
Metro Ring 2 - CustomerA
=============
diagnostics results
Ring
id
2
Diag frame sent
1230
Syntax: show metro <ring-id> diag
This display shows the following information.
TABLE 81
This field...
Ring id
Diag state
RHP average time
Recommended hello time
Recommended Prefwing time
Diag frame sent
Diag frame lost
If the recommended hello time and preforwarding time are different from the actual settings and
you want to change them, refer to
Displaying MRP information
You can display the following MRP information:
•
•
Displaying topology group information
To display topology group information, enter the following command.
Syntax: show topology-group [<group-id>]
Refer to
BigIron RX Series Configuration Guide
53-1001986-01
Diag
RHP average
state
time(microsec)
enabled
125
Diag frame lost
0
CLI display of MRP ring diagnostic information
Topology group configuration information
Ring configuration information and statistics
"Displaying topology group information"
Displaying MRP information
Recommended
hello time(ms)
100
Displays...
The ring ID.
The state of ring diagnostics.
The average round-trip time for an RHP packet on the ring. The
calculated time has a granularity of 1 microsecond.
The hello time recommended by the software based on the RHP average
round-trip time.
The preforwarding time recommended by the software based on the
RHP average round-trip time.
The number of diagnostic RHPs sent for the test.
The number of diagnostic RHPs lost during the test.
"Configuring MRP"
on page 402.
on page 441 for more information.
Recommended
Prefwing time(ms)
300
14
411