Assign Virtual Links; Interfaces - Dell PowerConnect B-RX Configuration Manual

Block flooding of outbound LSAs on specific OSPF

interfaces

By default, the device floods all outbound LSAs on all the OSPF interfaces within an area. You can
configure a filter to block outbound LSAs on an OSPF interface. This feature is particularly useful
when you want to block LSAs from some, but not all, of the interfaces attached to the area.
After you apply filters to block the outbound LSAs, the filtering occurs during the database
synchronization and flooding.
If you remove the filters, the blocked LSAs are automatically re-flooded. You do not need to reset
OSPF to re-flood the LSAs.
NOTE
You cannot block LSAs on virtual links.
To apply a filter to an OSPF interface to block flooding of outbound LSAs on the interface, enter the
following command at the Interface configuration level for that interface.
BigIron RX(config-if-e10000-1/1)# ip ospf database-filter all out
The command in this example blocks all outbound LSAs on the OSPF interface configured on port
1/1.
Syntax: [no] ip ospf database-filter all out
To remove the filter, enter a command such as the following.
BigIron RX(config-if-e10000-1/1)# no ip ospf database-filter all out

Assign virtual links

All ABRs (area border routers) must have either a direct or indirect link to the OSPF backbone area
(0.0.0.0 or 0). If an ABR does not have a physical link to the area backbone, the ABR can configure
a virtual link to another router within the same area, which has a physical connection to the area
backbone.
The path for a virtual link is through an area shared by the neighbor ABR (router with a physical
backbone connection), and the ABR requiring a logical connection to the backbone.
Two parameters fields must be defined for all virtual links—transit area ID and neighbor router:
•
•
NOTE
By default, the Brocade router ID is the IP address configured on the lowest numbered loopback
interface. If the device does not have a loopback interface, the default router ID is the lowest
numbered IP address configured on the device. For more information or to change the router ID,
refer to
BigIron RX Series Configuration Guide
53-1001986-01
The transit area ID represents the shared area of the two ABRs and serves as the connection
point between the two routers. This number should match the area ID value.
The neighbor router field is the router ID (IP address) of the router that is physically connected
to the backbone, when assigned from the router interface requiring a logical connection. When
assigning the parameters from the router with the physical connection, the router ID is the IP
address of the router requiring a logical connection to the backbone.
"Changing the router ID" on page 180.
25
Configuring OSPF
687