Dell PowerConnect B-RX Configuration Manual page 781

1. Enabling SNMP traps for OSPF. (Refer to
2. Enable OSPF logging. (Refer to
Refer to
TABLE 109
Trap name
Interface State Change Trap
Virtual Interface State Change Trap
Neighbor State Change Trap
Virtual Neighbor State Change Trap
Interface Configuration Error Trap
Virtual Interface Configuration Error Trap
Interface Authentication Failure Trap
Virtual Interface Authentication Failure Trap
Interface Receive Bad Packet Trap
Virtual Interface Receive Bad Packet Trap
Interface Retransmit Packet Trap
Virtual Interface Retransmit Packet Trap
Originate LSA Trap
Originate MaxAge LSA Trap
Link State Database Overflow Trap
Link State Database Approaching Overflow Trap
Disabling and enabling SNMP traps for OSPF
By default, most SNMP trap generation for OSPF is enabled (Refer to
the OSPF trap default values). You can disable the generation of these traps by entering the
following CLI command.
BigIron RX(config-ospf-router)# no snmp-server trap ospf
To later re-enable the trap feature, enter snmp-server trap ospf.
To disable a specific OSPF trap, enter the command as no snmp-server trap ospf <ospf-trap>.
These commands are at the OSPF router Level of the CLI.
Here is a summary of OSPF traps supported on BigIron RX, their corresponding CLI commands, and
their associated MIB objects from RFC 1850. The first list are traps enabled by default:
•
•
•
•
•
BigIron RX Series Configuration Guide
53-1001986-01
page 709.)
Table 109 on page 709 for the list of the default settings for OSPF traps.
Default settings for OSPF traps
interface-state-change-trap – [MIB object: OspfIfstateChange]
virtual-interface-state-change-trap – [MIB object: OspfVirtIfStateChange
neighbor-state-change-trap – [MIB object:ospfNbrStateChange]
virtual-neighbor-state-change-trap – [MIB object: ospfVirtNbrStateChange]
interface-config-error-trap – [MIB object: ospfIfConfigError]
"Disabling and enabling SNMP traps for OSPF"
"Enabling OSPF logging" on page 710.)
default
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
25
Configuring OSPF
on
Table 109 on page 709 for
709