Displaying Is-Is Syslog Messages - Dell PowerConnect B-RX Configuration Manual

28
Displaying IPv4 IS-IS information
TABLE 132
This field...
Type
Pri
StateChgeTime

Displaying IS-IS Syslog messages

When logging is enabled, the device generates Syslog messages and SNMP traps for the following
IS-IS events:
•
•
You also can enable the device to generate Syslog messages and SNMP traps when an adjacency
with a neighbor comes up or goes down. To enable logging of adjacency changes, refer to
adjacency changes"
To display Syslog entries, enter the following command at any level of the CLI.
BigIron RX# show logging
Syslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)
Static Log Buffer:
Dynamic Log Buffer (50 lines):
00d00h00m42s:N:BGP Peer 192.147.202.10 UP (ESTABLISHED)
00d00h00m18s:N:ISIS L2 ADJACENCY UP 1234.1234.1234 on interface 2/8
00d00h00m08s:N:ISIS L1 ADJACENCY UP 1234.1234.1234 on interface 2/8
00d00h00m08s:N:ISIS L2 ADJACENCY UP 0000.86de.5520 on interface 5/1
00d00h00m00s:I:Warm start
The messages in this example indicate that the software has been reloaded (Warm start) and
adjacencies between the device and three ISs have come up.
Syntax: show logging
Table 133
882
IS-IS neighbor information (Continued)
Overload state (the device entering or leaving the overload state)
Memory overrun (IS-IS is demanding more memory than is available)
on page 869.
Buffer logging: level ACDMEINW, 3 messages logged
level code: A=alert C=critical D=debugging M=emergency E=error
I=informational N=notification W=warning
lists the IS-IS Syslog messages.
Displays...
The IS-IS type of the adjacency. The type can be one of the following:
•
ISL1 – Level-1 IS
•
ISL2 – Level-2 IS
•
ES – ES
NOTE: The device forms a separate adjacency for each IS-IS type. Thus,
if the device has both types of IS-IS adjacencies with the
neighbor, the display contains a separate row of information for
each adjacency.
The priority of this IS to be elected as the Designated IS in this broadcast
network.
The amount of time that has passed since the adjacency last changed
state.
"Logging
BigIron RX Series Configuration Guide
53-1001986-01