Displaying Ospfv3 Interface Information - Dell PowerConnect B-RX Configuration Manual

48
Displaying OSPFv3 information
TABLE 209
This field...
Prefix Options
Prefix
Intra-area prefix LSAs (Type 9) (Iap) fields
Number of Prefix
Referenced LS Type,
Referenced LS ID
Referenced
Advertising Router
Prefix Options
Metric
Prefix
Number of Prefix

Displaying OSPFv3 interface information

You can display a summary of information for all OSPFv3 interfaces or detailed information about a
specified OSPFv3 interface.
To display a summary of OSPFv3 interfaces, enter the following command at any CLI level.
BigIron RX# show ipv6 ospf interface
Interface
ethe 3/1
ethe 3/2
ethe 3/4
loopback 2 enabled
tunnel 1
tunnel 2
tunnel 6
Syntax: show ipv6 ospf interface [ethernet <port> | loopback <number> | tunnel <number> | ve
The ethernet | loopback | tunnel | ve parameter specifies the interface for which to display
information. If you specify an Ethernet interface, also specify the port number associated with the
interface. If you specify a loopback, tunnel, or VE interface, also specify the number associated
with the interface.
This display shows the following information.
1214
OSPFv3 detailed database information fields (Continued)
Displays...
An 8-bit field of capabilities that serve as input to various routing calculations:
•
NU – The prefix is excluded from IPv6 unicast calculations.
•
LA – The prefix is an IPv6 interface address of the advertising router.
•
MC – The prefix is included in IPv6 multicast routing calculations.
•
P – NSSA area prefixes are readvertised at the NSSA area border.
The IPv6 prefix included in the LSA.
The number of prefixes included in the LSA.
Identifies the router-LSA or network-LSA with which the IPv6 address prefixes are
associated.
The address of the neighboring router that advertised the route.
An 8-bit field describing various capabilities associated with the prefix.
The cost of using the advertised prefix.
The IPv6 prefix included in the LSA.
The number of prefixes included in the LSA.
OSPF Status State
up
enabled up
disabled down
up
disabled down
enabled up
up
<number>]
Area
DR 0
Loopback 0
P2P 0
BigIron RX Series Configuration Guide
53-1001986-01