Configuring Rate Limiting Policies; Configuring A Port-Based Rate Limiting Policy - Dell PowerConnect B-RX Configuration Manual

19

Configuring rate limiting policies

TABLE 98
.
Module type
4 x 10G
24 x 1G
Configuring rate limiting policies
Configuring rate-limiting policies involves using the rate-limit command and specifying the
requested rate and maximum burst at the interface level of the CLI.
Software release 02.4.00 adds rate limiting to outbound ports.

Configuring a port-based rate limiting policy

Only one port-based rate limiting policy can be applied to an inbound port.
To configure a port-based rate limiting policy, enter commands such as the following.
BigIron RX(config)# interface ethernet 1/1
BigIron RX(config-if-e1000-1/1)# rate-limit out 500000000 750000000
Average rate is adjusted to 499639656 bits per second
The commands configure a rate limiting policy for outbound traffic on port 1/1. The policy requests
to limit the rate on all inbound traffic to 500 Mbps with a maximum burst size of 750 Mbps. The
device adjusts the requested rate to 499639656 bits per second.
Syntax: [no] rate-limit input | output <requested-rate> <maximum-burst>
Input applies rate limiting to inbound traffic on the port. Input can be abbreviated as in.
Output applies rate limiting to outbound traffic on the port. Output can be abbreviated as out.
The <requested-rate> parameter specifies the maximum rate allowed on a port during a
one-second interval. The minimum configurable requested rate is 20,345 bps. The maximum
configurable rate limiting rate is near line-rate.
Refer to
502
Maximum # of rate limiting policies and VLANs w/ byte accounting permitted
per-PPCR
PPCR number
PPCR 1
PPCR 2
PPCR 3
PPCR 4
PPCR 1
PPCR 2
Notes:
•
For outbound ports with slow speed links (for example, GbE), the rate supported is in
0.65Mbps increments, starting with 0.65 Mbps. That is, supported rates are 0.65 Mbps,
1.3 Mbps, 1.95 Mbps, etc.
•
For 10GbE ports, the rate supported is in 10.375 Mbps increments, starting with
10.375Mbps. That is, supported rates are 10.375 Mbps, 20.75 Mbps, 31.125 Mbps, etc.
"Requested rate" on page 499 for more details.
Port # Max # of rate limiting policies based on ACLs and
VLANs + number of VLANs w/ byte accounting
enabled
1 126
2 126
3 126
4 126
1 - 12 115
13 - 24 115
BigIron RX Series Configuration Guide
53-1001986-01