Configuring A Global Or Site-Local Ipv6 Address With A; Manually Configured Interface Id As The Switch's; System-Wide Address - Dell PowerConnect B-RX Configuration Manual

43
Configuring an IPv6 host address for a BigIron RX running a switch image
Configuring an IPv6 host address for a BigIron RX running a switch
image
NOTE
This feature is only available on the BigIron RX when it is configured as a switch. For this feature to
work it must have the CHD code enabled on the BigIron RX.
In the router configuration, each port can be configured separately with an IPv6 address. This is
accomplished using the interface configuration process that is described in
each router interface"
When a BigIron RX is running a switch-only image of the code, individual ports cannot be
configured with an IP address (IPv4 or IPv6). In this situation the device has one IP address for the
management port, and one IP address for the system. This has previously been supported for IPv4
but not IPv6.
There is support for configuring an IPv6 address on the management port as described in
"Configuring the management port for an IPv6 automatic address configuration"
and for configuring a system-wide IPv6 address on the BigIron RX in switch mode. Configuration of
the system-wide IPv6 address is exactly like configuration of an IPv6 address in router mode except
that all of the IPv6 configuration is at the Global Config level instead of at the Interface Config level.
The process for defining the system-wide interface for IPv6 is described in the following sections:
•
•
•

Configuring a global or site-local IPv6 address with a

manually configured interface ID as the switch's

system-wide address

To configure a global or site-local IPv6 Address with a manually configured interface ID, as a
switch's system-wide address, enter a command such as the following at the Global Config level.
BigIron RX(config)#ipv6 address 2001:200:12D:1300:240:D0FF:FE48:4000:1/64
Syntax: ipv6 address <ipv6-prefix>/<prefix-length>
You must specify the <ipv6-prefix> parameter in hexadecimal using 16-bit values between colons
as documented in RFC 2373.
You must specify the <prefix-length> parameter in decimal value. A slash mark (/) must follow the
<ipv6-prefix> parameter and precede the <prefix-length> parameter.
1068
on page 1063.
"Configuring a global or site-local IPv6 address with a manually configured interface ID as the
switch's system-wide address"
"Configuring a global or site-local IPv6 address with an automatically computed EUI-64
interface ID as the switch's system-wide address"
Refer to the "Configuring a Link-Local IPv6 Address as the Switch's System-Wide Address " in
the BigIron RX Installation Guide.
on page 1068
on page 1069
"Configuring IPv6 on
on page 1066
BigIron RX Series Configuration Guide
53-1001986-01