Displaying The Route Selection - Dell PowerConnect B-RX Configuration Manual

To specify a non-default route from the mRTM, then a non-default route from the uRTM, then a
default route from the mRTM, and then a default route from the uRTM, enter commands such as
the following.
BigIron RX(config)# router pim
BigIron RX(config-pim-router)# route-precedence mc-non-default uc-non-default
mcdefault uc-default
The none option may be used to fill up the precedence table in order to ignore certain types of
routes. To use the unicast default route for multicast, enter commands such as the following.
BigIron RX(config)# router pim
BigIron RX(config-pim-router)#route-precedence mc-non-default mc-default
uc-non-default none
Syntax: [no] route-precedence {mc-non-default mc-default uc-non-default uc-default none}
Default value: route-precedence mc-non-default mc-default uc-non-default uc-default
Use the mc-non-default parameter to specify a multicast non-default route.
Use the mc-default parameter to specify a multicast default route.
Use the uc-non-default parameter to specify a unicast non-default route.
Use the uc-default parameter to specify a unicast default route.
Use the none parameter to ignore certain types of routes.
The no form of this command removes the configuration.

Displaying the route selection

Use the show ip pim sparse command to display the current route selection. The example below
displays the default route precedence selection.
BigIron RX(config)#show ip pim sparse
Global PIM Sparse Mode Settings
Hello interval : 30 Neighbor timeout : 105
Bootstrap Msg interval: 60 Candidate-RP Advertisement interval: 60
Join/Prune interval : 60 SPT Threshold : 1
Inactivity interval : 180 SSM Enabled : No
Hardware Drop Enabled : Yes
Route Selection : mc-non-default mc-default uc-non-default uc-default
---------+----------------+----+---+----------------------+------+-------------+
Interface|Local
---------+----------------+----+---+----------------------+------+-------------+
This example displays the route precedence selection as multicast non-default, then unicast
non-default, then multicast default, and then unicast default.
BigIron RX Series Configuration Guide
53-1001986-01
|Address
v12 100.4.8.2
v13 100.16.8.2
v124 124.0.0.1
v125 125.0.0.1
v126 126.0.0.1
v127 127.0.0.1
l1 1.0.8.1
Route selection precedence for multicast
|Mode|Ver| Designated Router
| | |Address
SM V2 Itself
SM V2 Itself
SM V2 Itself
SM V2 Itself
SM V2 Itself
SM V2 Itself
SM V2 Itself
|TTL |Multicast
Port |Thresh|Boundary
1 None
1 None
1 None
1 None
1 None
1 None
1 None
23
|
|
605