Displaying Pim Traffic Statistics - Dell PowerConnect B-FCXs Configuration Manual

Displaying PIM traffic statistics

To display PIM traffic statistics, use the following CLI method.
PowerConnect#show ip pim traffic
Port
e3/8
Port
v1
Port
v2
Total 37
IGMP Statistics:
Total Recv/Xmit 85/110
Total Discard/chksum
Syntax: show ip pim traffic
NOTE
If you have configured interfaces for standard PIM (dense mode) on the Layer 3 Switch, statistics for
these interfaces are listed first by the display.
This display shows the following information.
TABLE 138
This field...
Port
Hello
J/P
Register
RegStop
Assert
Total Recv/Xmit
Total Discard/chksum
Displaying and clearing PIM errors
If you want to determine how many PIM errors there are on the device, enter the following
command.
PowerConnect#show ip pim error
**** Warning counter pim route change = 1
HW tagged replication enabled, SW processed pkts 0
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Hello J/P
[Rx Tx] [Rx
19 19 32
Hello J/P
[Rx Tx] [Rx
18 19 0
Hello J/P
[Rx Tx] [Rx
0 19 0
57 32
0/0
Output of show ip pim traffic
Displays...
The port or virtual interface on which the PIM interface is configured.
The number of PIM Hello messages sent or received on the interface.
The number of Join/Prune messages sent or received on the interface.
NOTE: Unlike PIM dense, PIM Sparse uses the same messages for Joins and Prunes.
The number of Register messages sent or received on the interface.
The number of Register Stop messages sent or received on the interface.
The number of Assert messages sent or received on the interface.
The total number of IGMP messages sent and received by the Layer 3 Switch.
The total number of IGMP messages discarded, including a separate counter for those
that failed the checksum comparison.
Register
Tx] [Rx Tx]
0 0 0
Register
Tx] [Rx Tx]
20 0 0
Register
Tx] [Rx Tx]
0 0 16
0 0 0
PIM Sparse
RegStop Assert
[Rx Tx] [Rx
37 0 0
RegStop Assert
[Rx Tx] [Rx
0 0 0
RegStop Assert
[Rx Tx] [Rx
0 0 0
0 0 0
25
Tx]
0
Tx]
0
Tx]
0
0
761