Dell PowerConnect B-RX Configuration Manual page 764

25
Configuring OSPF
Configuring an OSPF point-to-point link
To configure an OSPF point-to-point link, enter commands such as the following.
BigIron RX(config)# interface eth 1/5
BigIron RX(config-if-1/5)# ip ospf network point-to-point
This command configures an OSPF point-to-point link on Interface 5 in slot 1.
Syntax: [no] ip ospf network point-to-point
Viewing configured OSPF point-to-point links
You can use the show ip ospf interface command to display OSPF point-to-point information. Enter
the following command at any CLI level.
BigIron RX# show ip ospf interface 192.168.1.1
Ethernet 2/1,OSPF enabled
Syntax: show ip ospf interface [<ip-addr>]
The <ip-addr> parameter displays the OSPF interface information for the specified IP address.
The following table defines the highlighted fields shown in the above example output of the show ip
ospf interface command.
TABLE 107
This field
IP Address
OSPF state
Pri
Cost
Options
692
IP Address 192.168.1.1, Area 0
OSPF state ptr2ptr, Pri 1, Cost 1, Options 2, Type pt-2-pt Events 1
Timers(sec): Transit 1, Retrans 5, Hello 10, Dead 40
DR: Router ID 0.0.0.0
BDR: Router ID 0.0.0.0
Neighbor Count = 0, Adjacent Neighbor Count= 1
Neighbor: 2.2.2.2
Authentication-Key:None
MD5 Authentication: Key None, Key-Id None, Auth-change-wait-time 300
Output of the show ip ospf interface command
Interface Address 0.0.0.0
Interface Address 0.0.0.0
Displays
The IP address of the interface.
ptr2ptr (point to point)
The link ID as defined in the router-LSA. This value can be one of the
following.
1 = point-to-point link
3 = point-to-point link with an assigned subnet
The configured output cost for the interface.
OSPF Options (Bit7 - Bit0):
•
unused:1
•
opaque:1
•
summary:1
•
dont_propagate:1
•
nssa:1
•
multicast:1
•
externals:1
•
tos:1
BigIron RX Series Configuration Guide
53-1001986-01