Displaying Ospf Abr And Asbr Information - Dell PowerConnect B-RX Configuration Manual

NOTE
You cannot use the extensive option in combination with other display options. The entire database
is displayed.
The link-state-id <ip-addr> parameter displays the External LSAs for the LSA source specified by
<IP-addr>.
The network option shows network information.
The nssa option shows network information.
The router-id <ip-addr> parameter shows the External LSAs for the specified OSPF router.
The sequence-number <num(Hex)> parameter displays the External LSA entries for the specified
hexadecimal LSA sequence number.
The summary option shows summary information.
TABLE 116
This field...
Index
Area ID
Type LS ID
Adv Rtr
Seq(Hex)
Age
Cksum

Displaying OSPF ABR and ASBR information

To display OSPF ABR and ASBR information, enter the following command at any CLI level.
BigIron RX># show ip ospf border-routers
Syntax: show ip ospf border-routers [<ip-addr>]
The <ip-addr> parameter displays the ABR and ASBR entries for the specified IP address.
BigIron RX#show ip ospf border-routers
1
1
1
1
Syntax: show ip ospf border-routers
BigIron RX Series Configuration Guide
53-1001986-01
CLI display of OSPF database link state information
router ID router type next hop router
10.65.12.1 ABR
10.65.12.1 ASBR
10.65.12.1 ABR
10.65.12.1 ASBR
Displaying OSPF information
Displays...
ID of the entry
ID of the OSPF area
Link state type of the route
ID of the advertised route
The sequence number of the LSA. The OSPF neighbor that sent the LSA
stamps the LSA with a sequence number. This number enables the
device and other OSPF routers to determine which LSA for a given route
is the most recent.
The age of the LSA in seconds.
The checksum for the LSA packet. The checksum is based on all the
fields in the packet except the age field. The device uses the checksum
to verify that the packet is not corrupted.
10.1.49.2
10.1.49.2
10.65.2.251
10.65.2.251
outgoing interface Area
v49 0
v49 0
v201 65
v201 65
25
723