Dell PowerConnect B-RX Configuration Manual page 1236

45
Displaying BGP4+ information
TABLE 204
This field...
Confederation Peers
Maximum Number of Paths Supported
for Load Sharing
Number of Neighbors Configured
Number of Routes Installed
Number of Routes Advertising to All
Neighbors
Number of Attribute Entries Installed
Neighbor Address
AS#
1164
BGP4+ summary information (Continued)
Displays...
The numbers of the local ASs contained in the confederation. This list
matches the confederation peer list you configure on the switch.
The maximum number of route paths across which the switch can
balance traffic to the same destination. The feature is enabled by
default but the default number of paths is 1. You can increase the
number from 2 – 8 paths. For more information, refer to the "Configuring
BGP4" chapter in the Router Configuration Guide.
The number of BGP4+ neighbors configured on this switch.
The number of BGP4+ routes in the switch's BGP4+ route table.
To display the BGP4+ route table, refer to
table"
The total of the RtSent and RtToSend columns for all neighbors.
The number of BGP4+ route-attribute entries in the switch's
route-attributes table. To display the route-attribute table, refer to
"Displaying BGP4+ route-attribute entries"
The IPv6 addresses of this switch's BGP4+ neighbors.
The AS number.
on page 1123.
BigIron RX Series Configuration Guide
"Displaying the BGP4+ route
on page 1130.
53-1001986-01