Dell PowerConnect B-RX Configuration Manual page 1296

48
Displaying OSPFv3 information
•
•
This display shows the following information.
TABLE 217
This field...
SPF node
Cost
Hops
Next Hops to Node
Parent Nodes
Child Nodes
For example, to display the SPF table for area 0, enter the following command at any level of the
CLI.
BigIron RX# show ipv6 ospf spf table area 0
SPF table for Area 0
Destination
R 1.1.1.1
N 223.223.223.223[88] ---- V6E---R-
Syntax: show ipv6 ospf spf table area <area-id>
The table parameter displays the SPF table.
The area <area-id> parameter specifies a particular area. You can specify the <area-id> in the
following formats:
•
•
This display shows the following information.
1224
As an IPv4 address; for example, 192.168.1.1
As a numerical value from 0 – 2,147,483,647
OSPFv3 SPF node information
Displays...
Each SPF node is identified by its router ID (IPv4 address). If the node is a child node,
it is additionally identified by an interface on which the node can be reached
appended to the router ID in the format <router-id>:<interface-id>.
The cost of traversing the SPF node to reach the destination.
The number of hops needed to reach the parent SPF node.
The IPv6 address of the next hop-router or the router interface through which to
access the next-hop router.
The SPF node's parent nodes. A parent node is an SPF node at the highest level of the
SPF tree, which is identified by its router ID.
The SPF node's child nodes. A child node is an SPF node at a lower level of the SPF
tree, which is identified by its router ID and interface on which the node can be
reached.
Bits Options
---- V6E---R-
As an IPv4 address, for example, 192.168.1.1
As a numerical value from 0 – 2,147,483,647
Cost Nexthop
1 fe80::2e0:52ff:fe91:bb37
1 ::
BigIron RX Series Configuration Guide
Interface
ethe 3/2
ethe 3/2
53-1001986-01