Dell PowerConnect B-RX Configuration Manual page 987

NOTE
When using SCP, you enter the scp commands on the SCP-enabled client, rather than the console
on the device.
NOTE
Certain SCP client options, including -p and -r, are ignored by the SCP server on the device. If an
option is ignored, the client is notified.
To copy a configuration file (c:\cfg\foundry.cfg) to the running configuration file on a device at
192.168.1.50 and log in as user terry, enter the following command on the SCP-enabled client.
C:\> scp c:\cfg\foundry.cfg terry@192.168.1.50:runConfig
If password authentication is enabled for SSH, the user is prompted for user terry's password
before the file transfer takes place.
To copy the configuration file to the startup configuration file.
C:\> scp c:\cfg\foundry.cfg terry@192.168.1.50:startConfig
To copy the configuration file to a file called config1.cfg on the PCMCIA flash card in slot 1 on a
management module.
C:\> scp c:\cfg\foundry.cfg terry@192.168.1.50:slot1:/config1.cfg
To copy the configuration file to a file called config1.cfg on the PCMCIA flash card in slot 2 on a
management module.
C:\> scp c:\cfg\foundry.cfg terry@192.168.1.50:slot2:/config1.cfg
To copy the running configuration file on a device to a file called c:\cfg\fdryrun.cfg on the
SCP-enabled client.
C:\> scp terry@192.168.1.50:runConfig c:\cfg\fdryrun.cfg
To copy the startup configuration file on a device to a file called c:\cfg\fdrystart.cfg on the
SCP-enabled client.
C:\> scp terry@192.168.1.50:startConfig c:\cfg\fdrystart.cfg
BigIron RX Series Configuration Guide
53-1001986-01
30
Using secure copy
915