Multicast Listener Discovery And Source Specific Multicast; Protocols (Mldv2) - Dell PowerConnect B-RX Configuration Manual

TABLE 221
This field...
allo-fail
up-limit
Displaying PIM traffic statistics
To display IPv6 PIM traffic statistics, enter the following command at any CLI level.
BigIron RX#show ipv6 pim traffic
Port
MLD Statistics:
Total Recv/Xmit 356/161
Total Discard/chksum
BigIron RX#
Syntax: show ipv6 pim traffic
This display shows the following information.
This field...
Port
Hello
J/P
Register
RegStop
Assert
Total Recv/Xmit
Total Discard/chksum

Multicast Listener Discovery and source specific multicast

protocols (MLDv2)

The Multicast Listener Discovery Version 2 (MLDv2) protocol is available on the BigIron RX that is
running IPv6. IPv6 routers use the MLDv2 protocol to discover multicast listeners, or nodes that
wish to receive multicast packets on directly attached links. MLDv2 supports source filtering, the
ability of a node to send reports on traffic that is from a specific address source or from all
multicast addresses except the specified address sources. The information is then provided to the
source specific multicast (SSM) routing protocols such as PIM-SSM.
BigIron RX Series Configuration Guide
53-1001986-01
Multicast Listener Discovery and source specific multicast protocols (MLDv2)
Output of Show IPvG PIM resource (Continued)
Displays...
Number of allocated notes that failed
Maximum number of nodes that can be allocated for a data structure. This may
or may not be configurable, depending on the data structure
Hello Join
[Rx Tx] [Rx
0/0
Displays...
The port or virtual interface on which the IPv6 PIM interface is configured.
The number of IPv6 PIM Hello messages sent or received on the interface.
The number of Join/Prune messages sent or received on the interface.
NOTE: Unlike PIM dense, PIM Sparse uses the same messages for Joins and
The number of Register messages sent or received on the interface.
The number of Register Stop messages sent or received on the interface.
The number of Assert messages sent or received on the interface.
The total number of IGMP messages sent and received by the device.
The total number of IGMP messages discarded, including a separate counter for
those that failed the checksum comparison.
Prune
Tx] [Rx Tx]
Prunes.
Assert
[Rx Tx]
49
1247