Dell PowerConnect B-RX Configuration Manual page 1358

A
Syslog messages
TABLE 224
Message level
Notification
Notification
Notification
Notification
Notification
Notification
Notification
Notification
1286
Brocade Syslog messages (Continued)
Message
Local TCP exceeds <num> burst packets,
stopping for <num> seconds!!
Transit TCP in interface <portnum> exceeds
<num> burst packets, stopping for <num>
seconds!!
ISIS L1 ADJACENCY DOWN <system-id> on
circuit <circuit-id>
ISIS L1 ADJACENCY UP <system-id> on
circuit <circuit-id>
ISIS L2 ADJACENCY DOWN <system-id> on
circuit <circuit-id>
ISIS L2 ADJACENCY UP <system-id> on
circuit <circuit-id>
ISIS ENTERED INTO OVERLOAD STATE
ISIS EXITING FROM OVERLOAD STATE
Explanation
Threshold parameters for local TCP traffic on
the device have been configured, and the
maximum burst size for TCP packets has
been exceeded.
The first <num> is the maximum burst size
(maximum number of packets allowed).
The second <num> is the number of seconds
during which additional TCP packets will be
blocked on the device.
Note: This message can occur in response to
an attempted TCP SYN attack.
Threshold parameters for TCP transit
(through) traffic have been configured on an
interface, and the maximum burst size for
TCP packets on the interface has been
exceeded.
The <portnum> is the port number.
The first <num> is the maximum burst size
(maximum number of packets allowed).
The second <num> is the number of seconds
during which additional TCP packets will be
blocked on the interface.
Note: This message can occur in response to
an attempted TCP SYN attack.
The device's adjacency with this Level-1 IS
has gone down.
The <system-id> is the system ID of the IS.
The <circuit-id> is the ID of the circuit over
which the adjacency was established.
The device's adjacency with this Level-1 IS
has come up.
The <system-id> is the system ID of the IS.
The <circuit-id> is the ID of the circuit over
which the adjacency was established.
The device's adjacency with this Level-2 IS
has gone down.
The <system-id> is the system ID of the IS.
The <circuit-id> is the ID of the circuit over
which the adjacency was established.
The device's adjacency with this Level-2 IS
has come up.
The <system-id> is the system ID of the IS.
The <circuit-id> is the ID of the circuit over
which the adjacency was established.
The device has set the overload bit to on (1),
indicating that the device's IS-IS resources
are overloaded.
The device has set the overload bit to off (0),
indicating that the device's IS-IS resources
are no longer overloaded.
BigIron RX Series Configuration Guide
53-1001986-01