Dell PowerConnect B-RX Configuration Manual page 956

28
Displaying IPv4 IS-IS information
BigIron RX# show isis interface
Total number of IS-IS Interfaces: 1
Interface: Eth 7/1
Circuit State: UP Circuit Mode: LEVEL-1-2
Circuit Type: BCAST Passive State: FALSE
Circuit Number: 0x01, MTU: 1497
Authentication password: None
Level-1 Metric: 10, Level-1 Priority: 64
Level-1 Hello Interval: 10 Level-1 Hello Multiplier: 3
Level-1 Designated IS: RX-01 Level-1 DIS Changes: 8
Level-2 Metric: 10, Level-2 Priority: 64
Level-2 Hello Interval: 10 Level-2 Hello Multiplier: 3
Level-2 Designated IS: RX-01 Level-2 DIS Changes: 8
Next IS-IS LAN Level-1 Hello in 9 seconds
Next IS-IS LAN Level-2 Hello in 5 seconds
Number of active Level-1 adjacencies: 1
Number of active Level-2 adjacencies: 1
Circuit State Changes: 1 Circuit Adjacencies State Changes: 6
Rejected Adjacencies: 0
Circuit Authentication Fails: 0 Bad LSPs: 0
Control Messages Sent: 602 Control Messages Received: 2212
IP Enabled: TRUE
IP Address and Subnet Mask:
Syntax: show isis interface [brief | ethernet <slot-number>/<port-number> | loopback <number>
This display shows the following information.
TABLE 134
This field...
Total number of IS-IS interfaces
Interface
Local Circuit Number
Circuit Type
Circuit Mode
Circuit State
884
4.1.1.2 255.255.255.0
| ve <number>]
IS-IS Interface information
Displays...
The number of interfaces on which IS-IS is enabled.
The port or virtual interface number to which the information listed
below applies.
The ID that the instance of IS-IS running on the interface applied to the
circuit between this interface and the interface at the other end of the
link.
The type of IS-IS circuit running on the interface. The circuit type is set to
BCAST (broadcast).
The IS-IS type in use on the circuit. The mode can be one of the
following:
•
LEVEL-1
•
LEVEL-2
•
LEVEL-1-2
The state of the circuit, which can be one of the following:
•
DOWN
•
UP
BigIron RX Series Configuration Guide
53-1001986-01