Displaying Summary Mbgp Information; Displaying The Active Mbgp Configuration - Dell PowerConnect B-RX Configuration Manual

TABLE 205
Command
show ipv6 mbgp dampened-paths
show ipv6 mbgp flap-statistics
show ipv6 mbgp filtered-routes

Displaying summary MBGP information

To display summary MBGP information, enter the following command at any CLI prompt.
BigIron RX# show ipv6 mbgp summary
Router ID: 9.9.9.1
Confederation Identifier : not configured
Confederation Peers:
Maximum Number of Paths Supported for Load Sharing : 1
Number of Neighbors Configured : 1, UP: 1
Number of Routes Installed : 5677
Number of Routes Advertising to All Neighbors : 5673
Number of Attribute Entries Installed : 3
Neighbor Address
166.1.1.2
Syntax: show ipv6 mbgp summary
NOTE
This command's display looks similar to the display for the show ipv6 bgp config command.
However, the show ipv6 mbgp config command lists only the MBGP neighbors, whereas the show
ipv6 bgp config command lists only the BGP neighbors.

Displaying the Active MBGP Configuration

To display the active MBGP configuration information contained in the running-config without
displaying the entire running-config, enter the following command at any level of the CLI.
BigIron RX Series Configuration Guide
53-1001986-01
IPv6 MBGP Show commands (Continued)
BGP4 Summary
Local AS Number : 200
AS#
200
Displaying IPv6 MBGP information
Description
Displays IPv6 MBGP paths that have been dampened by route flap
dampening.
Displays route flap dampening statistics.
Displays routes that have been filtered out.
State Time Rt:Accepted Filtered Sent
ESTAB 0h24m54s 3
ToSend
0 5673 0
46
1173