Applying Acls To Interfaces; Reapplying Modified Acls; Acl Automatic Rebind; Manually Setting The Acl Rebind - Dell PowerConnect B-RX Configuration Manual

21

Applying ACLs to interfaces

Applying ACLs to interfaces
Configuration examples in the section
that you apply ACLs to interfaces using the ip access-group command. This section present
additional information about applying ACLs to interfaces. Configuration examples for super ACLs
appear in the section

Reapplying modified ACLs

If you make an ACL configuration change, you must reapply the ACLs to their interfaces for the
change to take effect.
An ACL configuration change includes any of the following:
•
•
•

ACL automatic rebind

Beginning wirh release 02.6.00, the ACL automatic rebind feature allows the newly changed ACL
filter definitions to be automatically applied to the ports where the ACL was bound without using
the "ip rebind-acl" command.
NOTE
Brocade recommends that this feature only be used when a small number of ACL filters are
configured, otherwise a delay may be observed.
Enter commands such as the following to enable ACL automatic rebind.
BigIron RX(config)# auto-acl-rebind
Syntax: [no] auto-acl-rebind

Manually setting the ACL rebind

To reapply ACLs following an ACL configuration change, enter the following command at the global
CONFIG level of the CLI.
BigIron RX(config)# ip rebind-acl all
Syntax: [no] ip rebind-acl <num> | <name> | all

Applying ACLs to a virtual routing interface

You can apply an ACL to a virtual routing interface for the inbound traffic direction only. The virtual
interface is used for routing between VLANs, and contains all the ports within the VLAN. You also
can specify a subset of ports within the VLAN containing a specified virtual interface when
assigning an ACL to that virtual interface.
Use this feature when you do not want the ACLs to apply to all the ports in the virtual interface's
VLAN or when you want to streamline ACL performance for the VLAN.
554
"Configuring super ACLs"
Adding, changing, or removing an ACL or an entry in an ACL
Changing a PBR policy
Changing ToS-based QoS mappings
"Configuring numbered and named ACLs"
on page 534.
on page 521 show
BigIron RX Series Configuration Guide
53-1001986-01