Dell PowerConnect B-RX Configuration Manual page 1257

TABLE 206
This field...
Number of accepted routes from a
specified neighbor (appears only in
display for all routes)
Status codes
Prefix
Status
Age
Next Hop
Learned from Peer
LOCAL_PREF
MED
Origin
Weight
AS-PATH
Displaying IPv6 neighbor route summary information
You can display route summary information for all neighbors or a specified neighbor only.
For example, to display summary information for neighbor 2000:4::110, enter the following
command at any level of the CLI.
BigIron RX Series Configuration Guide
53-1002253-01
Detailed best and unreachable routes from a BGP4+ neighbor
Displays...
For information about this field, refer to
For information about this field, refer to
For information about this field, refer to
For information about this field, refer to
The age of the route, in seconds.
For information about this field, refer to
The IPv6 address of the neighbor from which this route is learned. "Local
Router" indicates that the switch itself learned the route.
For information about this field, refer to
The value of the RIB route's MED attribute. If the route does not have a
metric, this field is blank.
The source of the route information. The origin can be one of the
following:
•
•
•
When BGP4+ compares multiple routes to a destination to select the
best route, IGP is preferred over EGP and both are preferred over
INCOMPLETE.
For information about this field, refer to
For information about this field, refer to
Displaying BGP4+ information
EGP – The routes with this set of attributes came to BGP4+ through
EGP.
IGP – The routes with this set of attributes came to BGP4+ through
IGP.
INCOMPLETE – The routes came from an origin other than one of
the above. For example, they may have been redistributed from
OSPFv3 or RIPng.
45
Table 205 on page 1179.
Table 205 on page 1179.
Table 205 on page 1179.
Table 205 on page 1179.
Table 205 on page 1179.
Table 205 on page 1179.
Table 205 on page 1179.
Table 205 on page 1179.
1181