Dell PowerConnect B-RX Configuration Manual page 1279

TABLE 210
Arguments...
<ipv6-source-prefix>/<prefix-leng
th>
<ipv6-destination-prefix>/<prefix
-length>
any
host
icmp-type
icmp code
icmp-message
tcp
udp
<ipv6-source-prefix>/<prefix-leng
th>
<ipv6-destination-prefix>/<prefix
-length>
any
host
BigIron RX Series Configuration Guide
53-1002253-01
Syntax descriptions (Continued)
Description...
The <ipv6-source-prefix>/<prefix-length> parameter specify a source prefix
and prefix length that a packet must match for the specified action (deny or
permit) to occur. You must specify the <ipv6-source-prefix> parameter in
hexadecimal using 16-bit values between colons as documented in RFC 2373.
You must specify the <prefix-length> parameter as a decimal value. A slash
mark (/) must follow the <ipv6-prefix> parameter and precede the
<prefix-length> parameter.
The <ipv6-destination-prefix>/<prefix-length> parameter specify a
destination prefix and prefix length that a packet must match for the specified
action (deny or permit) to occur. You must specify the
<ipv6-destination-prefix> parameter in hexadecimal using 16-bit values
between colons as documented in RFC 2373. You must specify the
<prefix-length> parameter as a decimal value. A slash mark (/) must follow
the <ipv6-prefix> parameter and precede the <prefix-length> parameter
When specified instead of the <ipv6-source-prefix>/<prefix-length> or
<ipv6-destination-prefix>/<prefix-length> parameters, matches any IPv6
prefix and is equivalent to the IPv6 prefix::/0.
Allows you specify a host IPv6 address. When you use this parameter, you do
not need to specify the prefix length. A prefix length of all128 is implied.
ICMP packets can be filtered by ICMP message type. The type is a number
from 0 to 255.
ICMP packets, which are filtered by ICMP message type can also be filtered by
the ICMP message code. The code is a number from 0 to 255.
ICMP packets,are filtered by ICMP messages. Refer to
configurations"
Indicates the you are filtering TCP packets.
Indicates the you are filtering UDP packets.
The <ipv6-source-prefix>/<prefix-length> parameter specify a source prefix
and prefix length that a packet must match for the specified action (deny or
permit) to occur. You must specify the <ipv6-source-prefix> parameter in
hexadecimal using 16-bit values between colons as documented in RFC 2373.
You must specify the <prefix-length> parameter as a decimal value. A slash
mark (/) must follow the <ipv6-prefix> parameter and precede the
<prefix-length> parameter.
The <ipv6-destination-prefix>/<prefix-length> parameter specify a
destination prefix and prefix length that a packet must match for the specified
action (deny or permit) to occur. You must specify the
<ipv6-destination-prefix> parameter in hexadecimal using 16-bit values
between colons as documented in RFC 2373. You must specify the
<prefix-length> parameter as a decimal value. A slash mark (/) must follow
the <ipv6-prefix> parameter and precede the <prefix-length> parameter
When specified instead of the <ipv6-source-prefix>/<prefix-length> or
<ipv6-destination-prefix>/<prefix-length> parameters, matches any IPv6
prefix and is equivalent to the IPv6 prefix::/0.
Allows you specify a host IPv6 address. When you use this parameter, you do
not need to specify the prefix length. A prefix length of all128 is implied.
Configuring an IPv6 ACL
on page 1205 for a list of ICMP message types.
47
"ICMP message
1203