Clearing Route Flap Dampening Statistics; Clearing Bgp4+ Local Route Information; Clearing Bgp4+ Neighbor Information - Dell PowerConnect B-RX Configuration Manual

Syntax: clear ipv6 bgp dampening [<ipv6-prefix>/<prefix-length>]
You must specify the <ipv6-prefix> parameter in hexadecimal using 16-bit values between colons
as documented in RFC 2373.
You must specify the <prefix-length> parameter as a decimal value. A slash mark (/) must follow
the <ipv6-prefix> parameter and precede the <prefix-length> parameter.
To un-suppress a specific route, enter a command such as the following.
BigIron RX# clear ipv6 bgp dampening 2001:e0ff::/32
This command un-suppresses only the routes for network 2001:e0ff::/32.

Clearing route flap dampening statistics

The switch allows you to clear all route flap dampening statistics or statistics for a specified IPv6
prefix or a regular expression.
NOTE
Clearing the dampening statistics for a route does not change the dampening status of the route.
To clear all the route dampening statistics, enter the following command at the Privileged EXEC
level or any of the Config levels of the CLI:
BigIron RX# clear ipv6 bgp flap-statistics
Syntax: clear ipv6 bgp flap-statistics [<ipv6-prefix>/<prefix-length> | neighbor <ipv6-address> |
The <ipv6-prefix>/<prefix-length> parameter clears route flap dampening statistics for a specified
IPv6 prefix. You must specify the <ipv6-prefix> parameter in hexadecimal using 16-bit values
between colons as documented in RFC 2373. You must specify the <prefix-length> parameter as a
decimal value. A slash mark (/) must follow the <ipv6-prefix> parameter and precede the
<prefix-length> parameter.
The neighbor <ipv6-address> parameter clears route flap dampening statistics only for routes
learned from the neighbor with the specified IPv6 address.
The regular-expression <regular-expression> parameter is a regular expression.

Clearing BGP4+ local route information

You can clear locally imported or routes redistributed into BGP4+.
To clear all local route information, enter the following command at the Privileged EXEC level or any
of the Config levels of the CLI.
BigIron RX# clear ipv6 bgp local routes
Syntax: clear ipv6 bgp local routes

Clearing BGP4+ neighbor information

You can perform the following tasks related to BGP4+ neighbor information:
•
BigIron RX Series Configuration Guide
53-1002253-01
regular-expression <regular-expression>]
Clear diagnostic buffers.
Clearing BGP4+ information
45
1139