Displaying Acls - Dell PowerConnect B-RX Configuration Manual

The following example shows the comment text for the ACL named "rtr" in a show ipv6 access-list
display.
BigIron RX# show ipv6 access-list rtr
ipv6 access-list rtr: 3 entries
10: remark This entry permits ipv6 packets from 3002::2 to any destination
10: permit ipv6 host 3000::2 any
20: remark This entry denies udp packets from any source to any destination
20: deny udp any any
30: remark This entry denies IPv6 packets from any source to any destination
30: deny ipv6 any any
Syntax: show ipv6 access-list [<access-list-name>]
For the <access-list-name> parameter, specify the name of an IPv6 ACL created using the ipv6
access-list command.
Use the all keyword to display all IPv6 ACLs configured on the device.

Displaying ACLs

To display the ACLs configured on a device, enter the show ipv6 access-list command. Here is an
example.:
BigIron RX# show ipv6 access-list
ipv6 access-list fdry: 8 entries
10: permit ipv6 host 3000::2 any
20: permit udp 3000::/16 any gt nfs
30: deny icmp host 5000::5 host 6000::3 echo-request
40: permit ipv6 host 3002::2 any
50: deny udp 3000::/16 4000::/16 gt nfs
60: permit tcp any any established
70: permit udp any any gt nfs
80: remark this is last entryipv6 access-list fdry: 3 entries
Syntax: show ipv6 access-list [<access-list-name>]
BigIron RX Series Configuration Guide
53-1001810-01
47
Displaying ACLs
1197