Displaying Summary Mbgp Information - Dell PowerConnect B-RX Configuration Manual

TABLE 202
Command
show ipv6 mbgp peer-group
show ipv6 mbgp routes
show ipv6 mbgp
<ipv6-addr>[/<prefix>]
show ipv6 mbgp attribute-entries
show ipv6 mbgp dampened-paths
show ipv6 mbgp flap-statistics
show ipv6 mbgp filtered-routes

Displaying summary MBGP information

To display summary MBGP information, enter the following command at any CLI prompt.
BigIron RX# show ipv6 mbgp summary
Router ID: 9.9.9.1
Confederation Identifier : not configured
Confederation Peers:
Maximum Number of Paths Supported for Load Sharing : 1
Number of Neighbors Configured : 1, UP: 1
Number of Routes Installed : 5677
Number of Routes Advertising to All Neighbors : 5673
Number of Attribute Entries Installed : 3
Neighbor Address
166.1.1.2
Syntax: show ipv6 mbgp summary
NOTE
This command's display looks similar to the display for the show ipv6 bgp config command.
However, the show ipv6 mbgp config command lists only the MBGP neighbors, whereas the show
ipv6 bgp config command lists only the BGP neighbors.
BigIron RX Series Configuration Guide
53-1001810-01
IPv6 MBGP Show commands (Continued)
BGP4 Summary
Local AS Number : 200
AS#
200
Displaying IPv6 MBGP information
Description
Displays information about IPv6 MBGP peer groups.
Displays IPv6 MBGP routes.
Displays a specific IPv6 MBGP route.
Displays IPv6 MBGP route attributes.
Displays IPv6 MBGP paths that have been dampened by route flap
dampening.
Displays route flap dampening statistics.
Displays routes that have been filtered out.
State Time Rt:Accepted Filtered Sent
ESTAB 0h24m54s 3
ToSend
0 5673 0
46
1181