Table of Contents
Advertisement
To create the control VLAN for this FRRP group, use the following commands on the switch that is to act as
the Master node.
1
Create a VLAN with this ID number.
CONFIGURATION mode.
interface vlan vlan-id
VLAN ID: from 1 to 4094.
2
Tag the specified interface or range of interfaces to this VLAN.
CONFIG-INT-VLAN mode.
tagged interface {range}
Interface:
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port[/
subport] information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
3
Assign the Primary and Secondary ports and the control VLAN for the ports on the ring.
CONFIG-FRRP mode.
interface primary interface secondary interface control-vlan vlan id
Interface:
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port[/
subport] information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
4
Configure the Master node.
CONFIG-FRRP mode.
mode master
5
Identify the Member VLANs for this FRRP group.
CONFIG-FRRP mode.
member-vlan vlan-id {range}
VLAN-ID, Range: VLAN IDs for the ring's member VLANS.
6
Enable FRRP.
CONFIG-FRRP mode.
no disable
Configuring and Adding the Member VLANs
Control and member VLANS are configured normally for Layer 2. Their status as Control or Member is
determined at the FRRP group commands.
For more information about configuring VLANS in Layer 2 mode, refer to the
Be sure to follow these guidelines:
Layer 2
chapter.
Force10 Resilient Ring Protocol (FRRP)
406
Advertisement
Table of Contents
Troubleshooting
