L3 Features > Ipv4 Route Table; L3 Features > Ipv6 Interface - D-Link DXS-1210-10TS User Manual

D-Link DXS-1210 Series User Manual
IP Address: Specify the network address for the IPv4 static route.
Mask: Specify the mask address for the IPv4 static route. If this is a default route, select the Default Route
checkbox.
Gateway: Enter the gateway address for IPv4 route. If this is a default route, then this is the default gateway.
Backup State: Each network can only have one primary route, and any other routes should be assigned to
the backup state. When the primary route failed, the switch also supports a floating static route, which means
that the user may create an alternative static route to a different next hop. This secondary next hop device
route is considered as a backup static route for when the primary static route is down. If the primary route is
lost, the backup route will become active.
Click Apply button to accept the changes made.
Click the Delete button to remove the specific entry.
L3 Features > IPv4 Route Table
The IPv4 Route Table page is used to view and configure the IPv4 route table settings.
Figure 4.121 – L3 Features > IPv4 Route Table
IP Address: Click the radio button and enter the destination IP address of the route to be displayed. The
longest prefix matched will be displayed.
Network Address: Click the radio button and enter the destination network address of the route to be
displayed.
Connected: Select this option to display only connected routes.
Hardware: Select this option to display only the routes that have been written into hardware.
Summary: Display a summary of the active routing entries.
Click the Find button to locate a specific entry based on the information entered.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
L3 Features > IPv6 Interface
The IPv6 Interface page is used to view and configure the IPv6 interface's settings.
Figure 4.122 – L3 Features > IPv6 Interface
Interface VLAN (1-4094): Enter the VLAN ID of the IPv6 interface.
Click Apply for the settings to take effect.
73